FLIGHT CONTROLLER F722-HDQUICK START GUIDE
MCU: 216MHz STM32F722RET6IMU: MPU6000 (SPI)Baro: BMP280 or DPS310 (I2C)Blackbox: 32M-byte Flash (SPI)OSD: support external DJI FPV OSD/FrskyOSD via UartNo analog MAX7456 OSD built-in6x Uarts with built-in inversion1x Softserial_Tx option10x Dshot/PWM outputs1x I2C 4x ADC (VBAT, Current, RSSI, AirSpeed)2x SH1.0_8pin connector (Vbat/G/Curr/Rx3/S1~S10)1x SH1.0_6pin connector for DJI FPV Air UnitSwitchable 8V output
9~36V DC IN (3~8S LiPo)BEC: 5V 2A cont. (Max.3A)BEC: 8V 2A cont. (Max.3A)LDO 3.3V: Max.200mABattery Voltage Sensor: 1:10 (Scale 110)Current Sensor: NoINAV target MATEKF722PXBetaFlight unified target MATEKF722HD
LAYOUT
5V: onboard BEC 5V 2A cont. 3A burst8V: onboard BEC 8V 2A cont. 3A burst*** 8V ON/OFF can be switched via Modes/USER1 (Default ON) Vbat: Battery voltageRX1 & TX1: UART1_RX & TXRX5 & TX5: UART5_RX & TXRX6 & TX6: UART6_RX & TX
Wiring (Multirotors)
INAV target MATEKF722PXBetaFlight unified target MATEKF722HD
*** If using DJI FPV Remote Controller, DO NOT enable USER1 Jun.2020 Rev 1.0
Wiring (Octocopter)
INAV target MATEKF722PXBetaFlight unified target MATEKF722HD
Wiring (Airplane)
Wiring (FrskyOSD)
Jun.2020 Rev 1.0www.mateksys.com
References
[xyz-ips snippet=”download-snippet”]