MEE audio X6 Wireless In-Ear Stereo Headset User Manual

USER MANUALENGINEERED FOR RICH AND CLEAR SOUND

WIRELESS IN-EAR STEREO HEADSETwww.MEEaudio.com/X6

BLUETOOTH SUPPORT PAGEPlease visit the Bluetooth Support page at MEEaudio.com/Bluetooth for video setup guides and troubleshooting information.https://goo.gl/Zrqt1p

MUSIC ENJOYMENT FOR EVERYONE

PRODUCT OVERVIEW

STEP 1 – CHARGING

Connect the Micro-USB charging cable to any powered USB port and to the charging port of the X6.The status indicator light will turn blue once the X6 is charged and ready for use.Close the USB port cover completely after charging for maximum sweat resistance.

STEP 2: PAIRING

Press and hold the Multifunction button for about 7 seconds until you hear the headset say “Pairing” and the light flashes red and blue.

Open the Bluetooth menu on the device you wish to pair (usually located in Settings > Bluetooth). If needed, select “search for devices”, “add new device”, or “refresh”.

Select “MEE audio X6” and allow pairing to complete. Use “0000” if a pin is required.Visit the Bluetooth Support Page at MEEaudio.com/Bluetooth for additional Bluetooth pairing and setup information.

STEP 3: SELECTING EARTIPS

Select the eartips with the best sound and comfort for your ears.

If your music sounds tinny or lacks bass, try different eartips.

STEP 4: WEARING THE X6

Identify the right and left earpieces.

Place the cable behind your neck and route the earhooks over your ears.

Place the earpieces in your ears. Adjust each earpiece until it fits flush in your ear and the eartip seals the ear canal.

Tighten the sliding cable cinch for the most secure fit.

FUNCTIONALITY AND CONTROLS

* You may need to bring your music player application up on the screen for media playback to start** Not all devices support this functionality

FACTORY RESET

FACTORY RESETTo perform a full reset, first put the X6 in standby mode (headset is powered on but not connected to any devices). Make sure to turn off Bluetooth or delete the “MEE audio X6” pairing from any nearby devices that have previously been paired with the X6.

Once in standby mode, press and hold the volume up and volume down buttons simultaneously until you hear a tone. All previously paired devices will be cleared from memory and a new pairing will need to be created before the X6 can be used.

WARNING

WARNINGUsing headphones at high to moderate volumes for extended periods of time will result in permanent hearing damage. It is advised you keep volume levels moderate to low at all times for your safety. Do not use while driving a car, cycling, operating machinery, or performing other activities that require hearing surrounding sounds.Keep the device and packaging out of reach of children.

ADDITIONAL INFORMATION

FOR ADDITIONAL SUPPORT• Visit our Bluetooth Support Guide at MEEaudio.com/Bluetooth for additional Bluetooth setup information.• View additional FAQs and troubleshooting guides at MEEaudio.com/Support.• Contact us at

WARRANTY

MEE audio products purchased from authorized resellers are covered by a 1-year manufacturer warranty. For more information, visit MEEaudio.com/Support

Have a question?Email

MEE audio and its logo are registered trademarks of S2E, Inc. All rights reserved.Siri® is a registered trademarks of Apple Inc. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MEE audio is under license. Other trademarks and trade names are those of their respective owners.

www.MEEaudio.com

MEE audio X6 Wireless In-Ear Stereo Headset User Manual – MEE audio X6 Wireless In-Ear Stereo Headset User Manual –

[xyz-ips snippet=”download-snippet”]


Posted

in

by