MERCUSYS MW300RE 300Mbps WiFi Range Extender Installation Guide

QuickInstallation GuideRange Extender

For technical support, the user guide, and more information, please visit http://www.mercusys.com/en/support.

Power on

Plug the extender into a power outlet near your router, and the Signal LED turns solid red.

Connect to the extender

Connect your wireless device to the extender’s network MERCUSYS_RE_XXXX.Note: The default SSID (network name) is printed on the product label at the back of the extender.

Configure

  • Launch a web browser and enter http://mwlogin.net. Create a password for future login attempts.
  • Select your router’s host network and enter thenetwork password when prompted.
  • Check the Signal LED on your extender. A Green or orange LED indicates a successful connection.

Relocate

To achieve better signal quality, plug in the extender halfway between your router and the Wi-Fi dead zone.

Enjoy!Connect your device to the extender using the extended SSID. The default Wi-Fi password is the same as your host network.

LED Explanation (For Range Extender Mode)

Off The power is off.
Blinking The extender is starting or connecting to thehost network.
Solid Red The extender is not connected to the hostnetwork.
Solid Green The extender is connected to the host networkand works well.
Solid Orange The extender is connected to the host network,but is too far away from the router.

FAQ (Frequently Asked Questions)

Q1 How do I configure the extender using WPS?

  • Plug the extender into a power outlet near your router, and wait until the Signal LED is lit and solid red.
  • Press the WPS button on your router.
  • Within 2 minutes, press the WPS or RESET/WPS button on the extender. The LED should change from blinking to a solid state, indicating a successful WPS connection.

Q2 How do I reset the extender?

  • With the extender powered on, press and hold the Reset or RESET/WPS button until the Signal LED turns off, then release the button. When the Signal LED turns solid on, the reset process is complete.

Q3 What should I do if I cannot access the extender’s web management page?

  • Make sure your wireless device is connected to the extended network using the extended SSID.
  • Verify that http://mwlogin.net is correctly entered in the web browser.
  • If you are using a computer, make sure it is set to obtain an IP address automatically.
  • Refer to Q2 to reset the extender and try again.

References

[xyz-ips snippet=”download-snippet”]