Align is a trademark of Moen® Incorporated ©2019 25300 Al Moen Drive • North Olmsted, OH 44070-8022Customer Service USA: 1-800-882-0116International Customer Service: 1-440-962-2217www.moen.com
Don’t forget to register and review your product by visiting moen.com/product-registration.
Installation Instructions for Towel Ring, 18 in. and 24 in. Towel Bars, and Pivoting Paper Holder
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tapeHardware Kit Contents: 4 anchors, 1 hex wrenchNote: Directions below are for installation into drywall. If installing product into a stud, use the wood screws only.
1) Position the mounting template on the wall in the desired location.2) Using a level, align the template and tape it to the wall.3) Drill two 1/4” holes at each mounting post location that corresponds to your product. (We recommend using the horizontal holes for drywall installation).4) Remove the template from the wall.5) Lightly tap anchors until flush with the wall.6) Remove mounting posts from the product assemblies by loosening each setscrew.7) One at a time, place each mounting post over anchors (notch facing downward) and insert screws through post into anchors.8) Tighten screws.
Towel Bars9) Assemble the towel bar and posts.10) While assembled, position each end post with setscrews facing down and place over both mounting posts. Tighten the setscrew at the bottom of each post.
Pivoting Paper Holder9) Place each assembly over the mounting posts with setscrews facing down. Pivoting post with bar should be on the left side. Tighten both setscrews.
Align Toilet Paper Holder User Manual – Align Toilet Paper Holder User Manual –
[xyz-ips snippet=”download-snippet”]