Motorola Solutions PMLN6533 2-Wire Earbud with Microphone/PTT User Guide

2-WIRE EARBUDWITH MICROPHONE/PTTPMLN6533

FOREWORD

RF Energy Exposure and Product Safety Guide for Portable Two-Way RadiosATTENTION!Before using this product, read the RF Energy Exposure and Product Safety Guide that ships with the radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulations.

ACOUSTIC SAFETY

Exposure to loud noises from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the radio’s volume, the less time is required before your hearing could be affected. Hearing damage from loud noise is sometimes undetectable at first and can have a cumulative effect.To protect your hearing:

• Use the lowest volume necessary to do your job. Turn up the volume only if you are in noisy surroundings.
• Turn down the volume before connecting the headset or earpiece.
• Limit the amount of time you use headsets or earpieces at high volume.
• When using the radio without a headset or earpiece, do not place the radio’s speaker directly against your ear.

DESCRIPTION

The PMLN6533 is a 2-wire earbud with a microphone and PTT combined. This pellet-style earpiece allows users to receive communication discreetly and is comfortable for extended wear.

OPERATION 

Attaching and Removing the Accessory to the Radio

1. Always turn the radio OFF before connecting the accessory.
2. Plug the accessory connector into the radio.
3. Turn the radio ON – make sure you do not set the volume level too high.NOTE: Once the accessory is connected, the radio’s microphone and radio’s speaker will be disabled.Users must use theaccessory microphone and earbud to transmit and listen to incoming calls.
4. To wear the earphone on the right ear, rotate the rear cover as shown in Figure 1 so that the marking “R” is on top and vice versa.
5. Adjust the volume on the radio to a comfortable listening level.

6. Press the Push-to-Talk (PTT) button, and speak into the microphone to confirm that the two-way communication works (the radio in-transmission light (LED) will be illuminated).
7. To receive, release the button.

8. Always turn your radio OFF before disconnecting the accessory batteries, or normal wear and tear.

Radios with this “Digital Symbol” are digital-capable radios and require the use of accessories with the same “Digital Symbol”. These accessories with the “Digital Symbol” have been optimized for digital audio Transmit and Receive.The use of non-approved accessories may result in the degradation of audio quality.Motorola and Mag One are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and is used under license. All other trademarks are the property of their respective owners.© 2020 Motorola Solutions, Inc. All rights reserved.