MPOW BH492A Wireless Music Receiver with Screen & Noise Isolator User Manual

MPOW BH492A Wireless Music Receiver with Screen & Noise Isolator

Packing List

Specifications

Diagram

1. AUX-Port
2. Screen
3. Pairing Button
4. Play/ Pause Button (Light on/off the Screen)
5. RCA Port
6. USB Charging Port
7. Power Switch
8. 3D Sound Button

Icons on the Screen

1. Wireless Device l
2. Wireless Device 2
3. Receiver Name
4. Play/Pause
5. Always-on Screen
6. Battery
7. Stereo Sound
8. Music Signal Spectrum

How to Pair

The receiver, by virtue of wireless receiving can transfer music from mobile phones computers and Pads to home audio speakers equipped with AUX audio input port.

1. The screen will light up when the power switch is slid to “ON”.
2. The receiver is ready to pair with the last paired device when the icon flashes on and off.
3. Insert 35mm audio cable into the AUX port of the receiver or insert RCA audio cable into the white and red ports of the receiver. and then insert the other end of an audio cable into your home audio speakers or vehicle sound system.
4. The receiver “MPOW BH492” is connected to your mobile phone with wireless function.
5. Music is being played when the icon lights up.

Simultaneously connect to two phones

The receiver can connect two phones at the same time.

1. The receiver is connected to your first phone by referring to the above steps.
2. After the first successful connection. the receiver is ready to pair with a second phone by pressing the button with the icon flashing quickly.
3. The receiver “MPOW BH492” is connected to your second phone with wireless function.
4. Two phones are successfully being connected to the receiver only when the icons and light up at the same time.

Operating Instructions

1. Turn on/off (interval between on/off should be longer than 5 seconds)The screen will light up when the power switch is slid to “ON”.The screen will light off when the power switch is slid to “OFF”
2. Auto Reconnection and PairingTurn on the receiver, it will automatically reconnect to and pair with the last paired device with the icon flashing quickly.
3. Always-on ScreenPress the button for 3 seconds to turn on/off the light lean icon on the screen {turn on :always-on screen, tum off :screen stays on for l minute).
4. Play MusicPlay/pause music by, pressing the button .
5. 3D Sound3D music is being played by pressing the button with its icon appearing on the screen.
6. Delete All Pairing InformationPress the button for 5 seconds to delete all pairing information from the receiver.
7. Low Battery WarningWhen the battery is low, the receiver will automatically warn you by flashing the battery icon on the screen and making alarm sound. Besides. the receiver will automatically shut down when the battery is lower than 3.0V

Notes

Since wireless signal will be blocked and absorbed by surrounding objects. please place the receiver and its paired devices In a barrier-free location during use, so that you can enjoy high-quality music.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This device complies with part 15 of the FCC Rules. Operation Is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

MPOW TECHNOLOGY CO.LIMITED[email protected]copyright© MPOW Inc. All rights reserved.www.xmpow.com