User Manual
Mpow Flame Solo Bluetooth Earbuds
AUTO PAIRING SETUP
- Take out both earbuds from the charging case. both earbuds will power on and enter paring mode in which the LED flashes red and blue alternately.
- Search Bluetooth name Mpow Flame Solo· and select it in your mobile phone.
RESET
- Tum off your device’s Bluetooth function.
- Take out both earbuds from the charging case and the earbuds will automatically enter into the pairing mode in which LED flashes blue and red alternately.
- Simultaneously keep pressing both 1iOlume up and 1iOlume dcmn buttons of either earbud for 3seconds.
- The paired information will be cleared and the earbuds will be off.
Q&A
► Note: Remove the insulating film on the charging connectors on both earbuds before charging it.
Ql : Why doesn’t music stop when I put Flame Solo back into the case.Reason 1: Earbuds might not be placed properly and not in the status of charging.Solution: Make sure Flame Solo is being properly placed.
Reason 2: The charging case is out of battery.Solution:
- To recharge the case.
- Or manually turn off the earbuds by keeping clicking the buttons on both earbuds for 5 seconds. The earbud’s light will keep on for 1 second and then goes out. with the voice prompt “Power off”.
Q2 : How to know the remaining battery of the charging case?When you open or close the case. you will know the battery level by checking the indicator:
Q3: How to know the charging status and the full power status of the case?
Q4: How to operate if the Bluetooth disconnect or fail to reconnect?Solution: Reset the earbuds by following the steps as previously mentioned.
Mpow Flame Solo Bluetooth Earbuds User Manual – Mpow Flame Solo Bluetooth Earbuds User Manual –
Questions about your Manual? Post in the comments!