SELFIE STICK TRIPODMpow isnap X2
MODEL: PA197A
Diagram
1. Phone Holder2. Aluminum Alloy Rod3. Remote Control4. Handle5. Tripod6. Support Frame
Pairing
Long press the camera key for 2s until the green light flashes. Turn on the wireless function on your phone and select “Mpow isnap X2”, the green light off if paired successfully.Tips: Long press the camera key for another 2s to turn it off.
Operation
- Use the Phone Holder
Rotate the phone holder 180° to the front of the selfie stick.
Unfold the folded side of the phone holder.
2. Install Your Phone
(1) Tightly push the clip to the right to mount your phone and make sure it is securely clamped.Tips: Please avoid blocking the side button of your phone.(2) Extend the Rod.3 Adjust the Angle
4 Unfold and Fix the Tripod
Unfold the tripod and push the center column upward until the tripod is fully expanded and stable. Place it on the flat surface to take photos.
5 Remove the Remote Control
Push the remote control up to take it out.Tips: Remove the insulating strip before use.6. Take Pictures with the Remote Control
Tips: Please make sure you’ve set your phone’s volume button as the shutter.7. Fold the Selfie Stick Tripod
Battery Replacement
When the power is low due to long-term use, tightly push the battery cover of the upper part of the remote control upward to replace the new button battery.
Tips:(1) The remote control will automatically sleep and the light turns off after 2mins if without any operation, just click the camera key to wake it up.(2) The remote control will automatically off after 30mins if without any operation, and you need to press the camera key for 2 seconds to turn it on.
www.xmpow.com | [email protected]MPOW TECHNOLOGY CO., LTDCopyright © MPOW Inc. All rights reserved.
References
[xyz-ips snippet=”download-snippet”]