nedia Desktop LED lamp User Guide

Nedis LTLGQ3M2xx Desktop LED Lamp Quick Start Guide

For more information see the extended manual

Intended use

The Nedis LTLGQ3M2xx is a desktop LED lamp with a built-in wireless charger.

This product is intended for indoor use only.

The product is not intended for professional use.

Any modification of the product may have consequences for safety, warranty and proper functioning.


Product Desktop LED lamp
Article number  LTLGQ3M2xx
Dimensions (l x w x h) 600 x 170 x 170 mm
Weight 402 g
Power input 12 VDC ; 2.0 A
Power 24 W
LED lamp
Rated power 5.5 W
Max. illumination 1000 Lux
Max. luminance 350 lm
Light modes Natural, cool, warm
Color temperature 2700 – 6500 K
Power input 100 – 240 VAC; 50 – 60 Hz
Power output 12.0 VDC ; 2.0 A
Power 24 W
Rated consumption power 21 W
Wireless charger
Power output 9 V / 1.1 A
Power 10 W
Radio frequency range 110 – 205 KHz
Radio frequency power – 10.99 dBuA/m @ 10 m
Timer Smart timer shutdown

Main parts

(image A)

  1. LED lamp
  2. Power input
  3. Power adapter
  4. Wireless charging area
  5. Light mode button
  6. Power button
  7. Timer button

Safety instructions


  • Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
  • Only use the product as described in this document.
  • Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
  • Do not drop the product and avoid bumping.
  • This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
  • Do not expose the product to water or moisture.
  • Disconnect the product from the power source and other equipment if problems occur.


  1. Plug the power adapter A3 into the power input A2.
  2. Plug the other end of A3 into a power outlet.

Using the lamp

  1. Press the power button A6 to switch on the LED lamp A1.
  2. Press and hold A6 to change the brightness of A1.
  3. Press the light mode button A5 to cycle through the different light modes.The light modes are Natural, Cool and Warm.
  4. Press and hold the timer button A7 to set a timer for 40 minutes. A1 flashes twice to indicate the timer is active. A1 switches off after the timer runs out.
  5. Press A6 to switch off A1.

Using the wireless charger

  1. Place your QI wireless charging enabled device onto the wireless charging area A4.
  2. Check the charging indication on your device to ensure your device is charging.


[xyz-ips snippet=”download-snippet”]