NetComm Dual Band AC1600 WiFi Gigabit Modem Router with VoIP User Manual

NetComm Dual Band AC1600 WiFi Gigabit
Modem Router with VoIP User Manual

Firmware Release Notes

CopyrightCopyright© 2017 NetComm Wireless Limited. All rights reserved.The information contained herein is proprietary to NetComm Wireless. No part of this document may be translated, transcribed,reproduced, in any form, or by any means without prior written consent of NetComm Wireless.Trademarks and registered trademarks are the property of NetComm Wireless Limited or their respective owners. Specificationsare subject to change without notice. Images shown may vary slightly from the actual product.

Note: This document is subject to change without notice.

This document covers the following product(s):NetComm Wireless VDSUADSL Dual Band AC1600 WiFi Gigabit Modem Router with VoIP (NF17ACV)

Firmware Details

Firmware Upgrade Instructions

  1. Connect the supplied RJ45 Ethernet cable from one of the Ethernet Ports on the back of the device to your computer.
  2. Connect the supplied power adapter to your router and press the on/off button to power the router on.
  3. Allow 60 – 90 seconds for the N F17 ACV to power up.
  4. Open a web browser (e.g. Internet Explorer, Firefox, Safari, etc) and type http:/1192.168.20.1 into the address bar and press Enter.
  5. At the login screen, type admin into both the Username and the Password fields and click OK.
  6. Select Management and then Update Firmware from the menu on the left side of the screen. Select Browse / Choose File to locate and load the firmware (NF17ACV.NC.AU-R5B019.EN_cfe_upgrade)
  7. Click Update Firmware to proceed. The process will take a few minutes until the router reboots itself.
  8. Once the upgrade is done, you will be brought to the Status page. Make sure the current firmware is R58019.
  9. Using the menu on the left side of the screen, select Management, then Settings and then Factory Reset. Click the Restore Default Settings button to reset the device.

Note: You must reset the router to the default settings after the firmware upgrade to ensure that it functions correctly.

Version History

R5B019

New Features

  • Username can now be changed.
  • Added support for Australian dial tone.
  • Added custom VLAN tagging to the Basic Setup page for VDSL / ETH WAN interface.

Enhancements

  • The password field is now checked for input exceeding 16 characters in length.
  • Enhanced the keepalive function on PPPoE connection.

Changes

  • Fixed an IPv6 issue with PPPoA connections.
  • Enabled SSH on LAN by default.
  • Fixed a policy routing issue.
  • Fixed a cosmetic issue on the QoS – Rule Order page.
  • Fixed an issue where 802.1 p marking is not allowed to be created in QoS settings.
  • Fixed an issue where a QoS rule did not apply correctly under the Ethernet WAN IPoE interface.
  • Removed user and support accounts to increase security.
  • Removed a redundant band selection option on the 2.4GHz / 5GHz Wireless page.
  • Increased VoIP stability.
R5B016 – Initial production release

New Features

  • None.

Enhancements

  • None.

www.netcommwireless.com

NetComm Wireless NF17ACV Firmware Release Notes

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , , , ,