NISBETS DC285 Mini oven Instruction Manual

Table of Contents

NISBETS DC285 Mini oven Instruction Manual

Safety Tips

Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
Consult Local and National Standards to comply with the following:
- Health and Safety at WorkLegislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations – Building Regulations
Caution! Hot surface!The temperature of accessible surfaces may be high when the appliance is operating. Always wear oven mittens when using the oven.
During and after cooking, the unit is still hot. Never touch the surface to avoid scalding.
DO NOT immerse the appliance in water.
DO NOT clean with jet/ pressure washers.
DO NOT leave the appliance unattended during operation.
DO NOT obstruct or cover the appliance in any way when in use.
Always switch off and disconnect the power supply to the appliance when not in use.
This appliance must only be used in accordance with these instructions and by persons competent to doso.
Keep all packaging away f rom children. Dispose of the packaging in accordance to the regulations of local authorities.
If the power cord is damaged, it must be replaced by a Nos bets Essentials agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Not suitable for outdoor use.
This appliance is not intended to be operated by means of an external timer or remote-control system.
Never use accessories which are not recommended by the manufacturer. They could pose a safety risk to the user and might damage the appliance. Only use original parts and accessories.
Nisbets Essentials recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
Nisbets Essentials recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your Nisbets Essentials product.

This appliance is intended to be used for commercial applications, for example in kitchens of restaurants, canteens, hospitals, etc. but not for household and industrial use.

Pack Contents

The following is included:

Mini Oven
Grill Rack
Baking tray, Baking tray handle
Rotisserie spit, Spit handle
Crumb tray
Instruction manual

Nisbets Essentials prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Nisbets Essentials dealer immediately.

Installation

Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials. Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation.
Keep the unit away from splashing water and countertop’s edge.

Operation

Before using for the first time

Wash the accessories and oven interior thoroughly.
Place the crumb tray, grill rack and baking tray inside the oven. Then close the door.
Set the temperature dial to the highest setting (230°C) and function dial to . Let the appliance run for 15 minutes to eliminate any manufacturing residues.
When the set time elapses, the appliance will beep then turn Off.
Allow to cool. Then appliance is now ready to use.

Cooking

Connect the appliance to the mains power supply.
Set the temperature dial, function dial and timer dial to desired settings. The power indicator light will come on and the appliance will start to work.
When the set time elapses, the appliance will beep then turn Off.

Warning

The timer dial also acts as the power switch. When set to “OFF”, the appliance willswitch off automatically.
During cooking, the temperature and cooking time can be adjusted at any time.
When the timer dial is set to “Stay On”, the appliance will keep working continuously.
Warning! Cooked food, metal rack, and door can be very hot. Handle with care!

Using the function dial

Dial position	Heating elements to use	Function Description
	Standby mode
	Upper and lower heating elements+ convection	This function is ideal for baking pork slice, chicken legs, chicken wings, potato flakes, poultry meat, chops, fish and so on with more evenly heating up.Tips for use:•Use of a meat thermometer is highly recommended.• You can select the cooking temperature and time as needed.•Check food is cooked 5-10 minutes before completion.
	Upper heating elements + convection
	Upper and lower heating elements	This function is ideal for cooking bread, pizza, and fowl in general. Tips for use:• You can select the cooking temperature and time as needed.• Upon completion, remove the food immediately, or the heat remaining in the oven will continue to toast and may dry out your food.
	Upper heating elements + rotisserie	This function is ideal for cooking whole chickens and fowl in general.Tips for use:• Use of a meat thermometer is highly recommended.• Ensure the baking tray is positioned on the lowest support guide to collect dripping oil.•Using the Rotisserie split: Insert the rotisserie spit through the centre of the food and secure using the 2 skewers (Inserting the skewers at different angles will help secure the food as it rotates). Then position then 2 ends of the rotisserie spit onto the spit sockets on the side walls, ensuring the square end is positioned on the right side.•Ensure to set the temperature dial to 230°C.•Check food is cooked 5-10 minutes before completion.
	Convection + rotisserie

Cleaning, Care & Maintenance

Warning: Always turn off and disconnect the appliance from the power supply before cleaning. Always allow the appliance to cool before cleaning.

Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
For stains on the interior walls, wipe with a cloth damped with some mild soapy solution. Ensure no moisture enters the inside of the cabinet.
Always wipe dry after cleaning.
A Nisbets Essentials dealer or qualified technician should carry out repairs if required.

Cleaning all removable trays and grill rack

After use, remove the parts from the appliance for cleaning.
Clean using warm, soapy water. Rinse thoroughly and dry well.
Re-locate into the appliance.

Note:

For best performance, Nisbets Essentials recommend that the appliance is cleaned after each day of operation.
Allow the appliance to cool and dry completely before storage. If storing the oven for long periods of time, make sure the oven is clean and free of food particles.

Troubleshooting

If your Nisbets Essentials appliance develops a fault, please check the following table before making a call to the Helpline.

Fault	Probable Cause	Solution
The unit is not working	The unit is not switched on	Check the unit is plugged in correctly and switched on
Plug or lead is damaged	Call Nisbets Essentials agent or qualified technician
Fuse in the plug has blown	Replace the plug fuse
Power supply	Check power supply
Appliance does not reach set temperature	Faulty temperature dial	Call Nisbets Essentials agent or qualified technician
Faulty element	Call Nisbets Essentials agent or qualified technician
Appliance heats up but indicator light does not come on	Bulb has expired	Call Nisbets Essentials agent or qualified technician
Power indicator light comes on but appliance does not heat up	Faulty temperature dial	Call Nisbets Essentials agent or qualified technician
Faulty element	Call Nisbets Essentials agent or qualified technician
Temperature dial set incorrectly	Check temperature dial

Technical Specifications

Model

Voltage

Power

Current

Dimensions h x w x d (mm)

Weight

Max. load of the tray/rack

DC285

220-240V~

50Hz-60Hz

1500W

13A

316 x 535 x 439

10.7kg

3.0kg

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.

The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed.

If in doubt consult a qualified electrician

Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/ or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area

Nisbets Essentials parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

Nisbets Essentials products have been approved to carry the following symbol:

REACH SVHC Disclosure

The Registration, Evaluation, Authorization and Restriction of Chemicals Regulation EC 1907/2006, commonly referred to as REACH, is a European regulation on chemicals and their safe use. With the publication of candidate lists for authorization, the European Chemicals Agency identifies sets of substances of very high concern (SVHC) that manufacturers must disclose to customers if used in their products above 0.1% by weight.

Based on the current version of the candidate list for authorization, this product contains the following SVHCs above the disclosure threshold:

Product Code	SVHC & Weight	CAS Number	Application
DC285	Lead ~0.4g	7439-92-1	Metal alloys and high-temperature solder (inside the plug, diode and thermal cut- out)

The SVHCs used in this product does not pose a safety risk to customers undernormal use conditions.

Disposal of this product must be to a licensed waste collection point, observe anylocal and national regulations.

DECLARATION OF CONFORMITY

Equipment Type	Model
Mini Oven with Rotisserie function -38Ltr	DC285
Application of Territory Legislation	Electrical Equipment (Safety) Regulations 2016
	EN 60335-1:2012 +A11:2014 +A13:2017
	EN 60335-2-9:2003+A1:2004+A2:2006+A12:2007 +A13:2010
	EN 62233:2008
	Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
	EN 55014-1:2017
	EN 55014-2:2015
	EN 61000-3-2:2014
	EN 61000-3-3:2013
	Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
	Equipment Regulations 2012 (S.I. 2012/3032)
Producer Name	Nisbets Essentials

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Date: 15th April 2021
Signature_________
Full Name: Ashley Hooper
Position: Technical & Quality Manager
Producer: Address: Fourth Way, Avonmouth, Bristol, BS11 8TB Great Britain

Contact:

UK	+44 (0)845 146 2887
Eire
NL	040 – 2628080
FR	01 60 34 28 80
BE-NL	0800-29129
BE-FR	0800-29229
DE	0800 – 1860806
IT	N/A
ES	901-100 133
PT	v [email protected]

References

Nisbets Catering Equipment & Supplies | Commercial Catering Equipment

[xyz-ips snippet=”download-snippet”]

Posted

2023-01-21

NISBETS

admin

Tags:

DC285 Mini oven, NISBETS