Noise Colorfit Pro 2 SmartWatch User Manual



Download and install NoiseFit Sport App

You can setup the watch through the NoiseFit Sport app for iOS or Android devices.Scan the QR code below with your smartphone camera or search for NoiseFit Sport in your app store.


Pairing process

  1. Turn on Bluetooth and GPS on your smartphone.
  2. Open the NoiseFit Sport app’s pairing menu.
  3. Select ColorFit Pro 2 from the menu.
  4. Click Ok to complete the pairing process.
  5. See below for one additional step on iPhones.
  • iPhones will not prompt you with any information unless you complete Bluetooth pairing with your ColorFit Pro 2 in the built-in Bluetooth settings on your iPhone after you complete the paring process in the NoiseFit Sport app.

Note: During the pairing process, NoiseFit Sport will prompt you to enable GPS and Bluetooth, and authorize NoiseFit Sport for GPS access on your mobile phone.

Synchronising Data

ColorFit Pro 2 can track your health data such as 24×7 heart-rate. It needs to be connected to the NoiseFit Sport app to record all this data. To synchronise ColorFit Pro 2 data with NoiseFit Sport, open the app and swipe down on the page. A sync prompt appears.

  • For iOS devicesOpen the iOS phone > set > bluetooth > search and click pair.Note: To prevent health data loss, please synchronise watch data at least once every 7 days as ColorFit Pro 2 cannot store data internally for more than 7 days.

Instruction for Use

1. Charging schematic: Connect and charge the ColorFit Pro 2 as shown above. Please charge your ColorFit Pro 2 for at least 2 hours before the rst time you use it.1. Wear/Replace the strapWear ColorFit Pro 2 a nger’s distance above your wrist bone. Wear the watch tight enough that no light can be seen from the heart rate sensor on the back of the watch. The watch should not move when you move your arms about.

Replace the strap.

Flip the switch and take out the wrist band.Tip: Wearing too loosely may affect the accuracy of heart rate data.

Operating Instructions

  1. Right Key FunctionsShort press the right key to return to the previous page Long press the right key to start
  2. Changing watch facesPress and hold the watch face to see the interface to choose watch faces.
  3. Using ColorFit Pro 2Swipe the screen to enter different modes

Function Introduction

  1. ColorFit Pro 2 ModesSports Mode: Lets you choose a Sports Mode. You can select which modes to show on your ColorFit Pro 2 with the app.Heart Rate: Perform a heart rate test or check your heart rate data for the day.Breathe: Helps you regulate your breathing and relax your mood.Alarm: View, turn off or turn on the alarm clock. You can add alarms with the app.Music: Control music playing on your smartphone. ColorFit Pro 2 cannot store or playback music on the watch.Stopwatch: Start a timer or a countdown.Sports Records: View recent sports recordings. For more functions like sleeping, please check the NoiseFit Sport app.ColorFit Pro features
  2. Recording Sports on ColorFit Pro 2To enter sports mode: Click the sports mode icon > Select the sports type > The sports countdown starts automatically.During sports: Pause recording with a short press of the right key. Resume recording with a short press of the right key.End sports : End recording your sports with a long press of the right key > Select the end button on the screen.

Cleaning and Maintenance

Wearing and caring for your ColorFit Pro 2

  1. Keep the product clean
  2. Keep the product dry
  3. Do not wear it too tight
  4. Do not use household cleaners to clean the watch. Use soap free detergent if you need to clean it

Safety and Product Information Notes

Battery warning: Do not disassemble, pierce or damage the battery. Do not disassemble the built-in batteries of non-replaceable battery devices. Do not use sharp objects to remove the battery.Health Warning: The watch’s optical heart rate sensor glows green and ashes. If you suffer from epilepsy or are sensitive to blinking light sources, please consult your physician to ask if you can wear this product.The device tracks your daily activities through sensors. These data are intended to tell you about your daily activities, such as steps, sleep, distance, heart rate and calories, but may not be completely accurate.The device, accessories, heart rate sensors and other relevant data are designed for entertainment and tness, not for medical purposes. They are not applicable to the diagnosis, monitoring, treatment or prevention of any diseases or symptoms. The heart rate data is for reference only. We are not responsible for any consequences caused by any data deviation.

Cycling Warning

Please maintain good judgment at all times and ride in a safe manner. Make sure your bike and hardware are properly maintained, and all components are properly installed.

Matters Needing Attention

  • Watch data needs to be kept once every 7 days to avoid data loss.
  • The watch has no waterproof effect on seawater, acidic and alkaline solutions, chemical reagents, and other corrosive liquid. The damage or defects caused by misuse or improper use are not covered by the warranty.
  • Sports mode supports up to 6 hours of exercise at a time.
  • The watch has a waterproof level of IP68 and supports cold water shower, swimming, but not diving.
  • Avoid wearing the watch too tight in daily use. Please keep the parts of the watch touching the skin dry.
  • When your heart rate is measured, keep your arm still during the testThe device meets the EU ROHS criterion. Please refer to IEC 62321, EU ROHS Directive 2011/65/EU, and revised directive.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:1. This device may not cause harmful interference, and2. this device must accept any interference received, including interference that may cause undesired operation.Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help cautionRISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONSOld electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the treatment of toxic substances.

Warranty Information

  1. What is covered in the Limited warranty period? Warranty is applicable on the Noise product including accessories on manufacturing defects (if any) for 1 Year from the date of purchase
  2. What are the things that are not covered in the warranty:• Product has been subject to unauthorized tampering, modication or repairs.• Product has suffered physical damage on the account of abuse, neglect, or improper use, handling, storage, installation, or testing, including any use that is not in accordance with the product manual, documentation, or other instructions provided along with the node product.• Product has suffered any misconduct.• Any other clause mentioned in our online return policy.Note: For further information on product replacement/refund related queries, please refer to the terms and conditions mentioned in our return policy section on

Customer Care Team

Thank you for shopping from For any assistance, please get in touch with our Customer Care Team at +91 88-82-132-132 or just drop an email at [email protected] We hope you have an amazing experience with the product.

Register Warranty for your and SupportExtendend Warranty



[xyz-ips snippet=”download-snippet”]