C3PCS Cast Aluminum Bistro SetSKU: SCD004-01INSTRUCTION MANUAL
INTRODUCTION
Thanks for purchasing and trusting NUUGARDEN with your home decorating plans. This product is furniture designed and made by NUUGARDEN Corp.We are committed to R&D innovation and to creating the most refined, diverse choice of outdoor collection.After unpacking and before every use, check whether the item shows any damages. In addition, check that you have all parts and hardware before assembly. If there is any damage, please do not use it and just call customer service at (800) 257-7108 or send an email to [email protected].If you do not have all the parts lists, have your dealer contacts us and they will be sent to you immediately.This furniture is intended for indoor and outdoor use. Please take time to read and follow the instruction below. Use the item as described in this operating manual. We accept no liability for damages caused by improper use.
ASSEMBLY INSTRUCTIONS
Step 1: Attach the front and back Legs (C, D) to the studs on the chairseat (B) using washers and nuts (L, M, N). Do not tighten the nuts.Step2: Attach the backrest (A) to the chair seat (B) using washers and nuts (L, M, N). Do not overtighten.Step3: Attach the right and left arm(E, F) using the bolts (K) and washers and nuts (H, I, J). Do not overtighten.Step4: Attach the right and left arm(E, F) using the bolts (G) and washers, nuts (H, I, J). Do not overtighten.Step5: Upon completion of full assembly and bolted up-all screws can be tightened down. Add the protect hats (O, P).Note: Please do not tighten any bolt until all bolts have been put in the right place.If you tighten one bolt, it may be causes other bolts out of position.
ASSEMBLY INSTRUCTIONS
Step1: Attach the 3 legs (C) to the tabletop (A) using bolts (D), washers, and nuts (E, F, G). Do not overtighten.Step2: Attach the 3 legs (C) to the legs support (B) using bolts(H), washers, and nuts (I, J, K). Do not overtighten.Step3: Upon completion of full assembly and bolted up-all screws can be tightened down. Add the protect hats (L, M).Note: Please do not tighten any bolt until all bolts have been put in the right place.If you tighten one bolt, it may be because other bolts are out of position.
CARE AND MAINTENANCE
Follow the instruction for the material of your special product to make sure that it stays in the best shape for as long as possible. The information below is only intended as a general guideline. For more information, please contact us.
- Only need to rinse it thoroughly with clean water to wash away dirt and grime. Never use abrasive cleaners on the furniture, since they can attack the surfaces and leave behind scratch marks.
- For the stubborn grime and stains, just use a soft sponge and mild soapy water and then dry it with a cloth or paper towel.
- Check the stability of the screws, nuts, and nut caps prior to each use.Tighten up them after one to two months’ use whenever required.
- Avoid improper use, and be careful not to scratch or damage the surface with sharp objects.
- When you move your furniture, make sure you lift it rather than pulling or pushing it to avoid damaging the floor, legs, and mounting.
CUSTOMER SERVICE
Thanks for purchasing this NUUGARDEN furniture. We are here to help you maximize your enjoyment and appreciation of it.Please do not hesitate to contact our customer service when you have any questions regarding assembly or accessories.Add 6366 Corley Road, Norcross, GA 30071.Tel: (800) 257-7108Web:http://www.nuugarden.comE-mail: [email protected]Service time: Mon-Fri, 8:30 AM-5:30 PM, EST
report this ad
References
[xyz-ips snippet=”download-snippet”]