Omega ORU50XL 52cm Under Cupboard Rangehood Instruction Manual

Omega ORU50XL 52cm Under Cupboard Rangehood Instruction Manual

Thank you for purchasing an Omega appliance

Tailored for the modern aesthetic and lifestyle of busy people, your new Omega Appliance will make a welcome addition to the family.

Omega caters to style-savvy customers who look for balance between stunning form and clever function. This means a combination of sleek, chic, sophisticated design yet effortless functionality.And we source from the best. The best craftsmanship. The best innovation. From the best international design-houses.

All brought together under an appliance that stands for design-led balance.

Please take the time to read through the following instruction manual to familiarise yourself with the installation, operation requirements and maintenance to ensure optimum performance.

READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING THE APPLIANCE.

It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference.The manufacturer will not be responsible for any damage to property or to persons caused by incorrect installation or improper use of the appliance.

Due to continual product development, Omega reserves the right to alter specifications and appearances without notice.

Important Safety Warnings

IMPORTANT: Read the assembly instruction section and safety precautions of this booklet carefully before removing the contents of this carton.

  1. In certain circumstances electrical appliances may be a safety hazard.
  2. This appliance is not intended for use by persons (including children) with reduced physical,sensory or mental capabilities, or lack of experience or knowledge, unless they have been givensupervision or instruction concerning the use of the appliance by a person responsible for theirsafety. Young children should be supervised to ensure that they do not play with the appliance.
  3. Do not check the status of the filters whilst the cooker hood is operating.
  4. Do not touch the light bulbs after use.
  5. Do not disconnect the appliance with wet hands.
  6. Do not disconnect the power supply by pulling on the cable.
  7. Do not flambé underneath the range hood.
  8. Avoid free flame, as it may cause damage to the filters and can be a fire hazard.
  9. Unplug the appliance before carrying out maintenance, cleaning or replacing lamps.
  10. If the power cord is damaged, it must be replaced by the manufacturer, an authorised service centre or similarly qualified persons to avoid a hazard.
  11. For indoor use only.
  12. It is recommended to operate the range hood prior to cooking.
  13. It is recommended to leave the range hood in operation for 15 minutes after cooking is terminated in order to completely eliminate cooking vapours and odours.
  14. Turn off the range hood when not in use.
  15. Do not use the range hood if it is damaged, especially the supply cord and the case
  16. Do not immerse the range hood in liquid.
  17. The exhaust air must not be discharged into a flue which is used for exhausting fumes from anappliance burning gas or other fuels (not applicable to appliances that only discharge the airback into the room).
  18. Regulations concerning the discharge of air have to be fulfilled.
  19. There shall be adequate ventilation of the room when the range hood is used at the same timeas appliances burning gas of other fuels (not applicable to appliances that only discharge the airback into the room).
  20. Clean the surface of the cooker hood regularly using a cloth moistened with denatured alcohol ora non-abrasive liquid detergent.
  21. There is a fire risk if cleaning is not carried out in accordance with the instructions.
  22. The 600mm units are intended for use above hobs that are 600mm wide and the 900mm unitsare intended for use above hobs that are 900mm wide.
  23. The range hood must be mounted at a minimum distance of 65cm above the cooking surface.
  24. CAUTION: Accessible parts may become hot when used with cooking appliances.
  25. Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

Appliance Details

Voltage:

220V-240V~/50Hz

Rated input power:

 193W
Lamp Max:

2 x 1.5W LED

Installation Instructions

Please ensure that all power is switched off before installing the range hood. Installation must be in accordance to the local electrical authority and codes. This range hood must be earthed at all times for the operators’ safety.

The G.P.O. for the range hood should be positioned to enable the user to turn the power off, to enable cleaning and any maintenance required.

Ensure that when installing the range hood, that it is protected from any possible damage from tools etc.

Ducting for this unit must be installed in accordance to the local authority. Ensure that the fixings used for this range hood are suitable.

Check the area where the range hood is to be fitted, to ensure that it is structurally sound.

Before using the appliance, remove the plastic coatings protecting the stainless steel finish.

Ensure that the wall is structurally sound, and is capable of carrying the weight of the range hood.It is recommended that the dimension be checked on the range hood before installing.

  1. The cooker hood should be placed at a distance of 65- 75cm (26-30inch) from the cooking surface for the best effect.
  2. Drill a hole in the cupboard, 490*265(mm) for modelORU50XL.
  3. Make sure the distance between the edge of the hole and the edge of the cupboard edge is at least 35mm. Take down the filter and remove the four screws on the panel.
  4. Use random accessory tighten screws fix the hood into cabinet.
  5. Use 4 screws fix the panel into body and equip the filter.
  6. Install one-way valve: put the one-way valve into air outlet, Put on the one-way valve with air outlet.

Operating Instructions

Note: Before the unit can be operated, it must be ducted.

  1. Push ‘Stop’ button, the motor will stop.
  2. Push the ‘Low’ button, the motor runs at low speed
  3. Push the ‘Mid’ button, the motor runs at mid speed.
  4. Push the ‘High’ button, the motor runs at high speed.
  5. Push the ‘Light’ button and the two lights will be on.
  6. Push it again and the light will turn off.

If your range hood does not function correctly when attempting any of the above, please ensure that your power is on and is functioning correctly. If the power seems to be functioning correctly in the house, there may be a problem with the range hood. Please call your authorized Omega service centre in this case to organize a service call.

Lamp Replacement

  1. Switch the unit off and disconnect from mains power first.
  2. Remove filter and read labels regarding maximum lamp ratings.
  3. Press the light face and remove by turning in anti-clockwise direction.
  4. Pull out the LED lamp carefully and replace with the same type and same rated LED LAMP (240V 1.5W MAX).
    • ILCOS-D Code for the lamp is: DBR-1.5/65-H-64
    • Max Wattage: 2 x 1.5W

Cleaning

SAFETY PRECAUTION

Before cleaning your rangehood or performing any maintenance, please ensure that the rangehood isturned off at the power point.

Do not use abrasive cleaners to clean the rangehood. The use of warm soapy water and a cloth arerecommended.

Ensure that the rangehood is cleaned regularly, as a build-up of grease and fat may occur otherwise.The filters on the rangehood must be cleaned regularly to maintain efficiency, and prevent grease build up.The filter mesh is made of a high density Stainless Steel. It is recommended that this is undertaken every 4 – 6 weeks, depending on frequency of use. The filters can be cleaned with warm soapy water or a cloth.Cleaning of the rangehood must be performed as described above; otherwise there is a possibility of a fire hazard due to grease and fat build up.

Troubleshooting

Fault Possible Cause Solution
Light on, but motor does not work Fan switch turned off Select a fan switch position.
Fan switch failed Contact Everdure Service.
Motor failed Contact Everdure Service.
Light does not work, motor does not work House fuses blown Reset/Replace fuses.
Power cord loose or disconnected Refit cord to power outlet. Switch power outlet on.
Oil leakage One-way valve and the air ventilation entrance are not tightly sealed Take down the one-way valve and seal with sealant.
Leakage from the connection of U-shaped section and cover Take U-shaped section down and seal.
Lights not working Broken/Faulty LED lamp Contact Everdure Service.
Insufficient suction The distance between the rangehood and the gas top is too far it the rangehood to the correct distance. Refit
The Rangehood inclines The fixing screw not tight enough Tighten the hanging screw and make it horizontal.

Australian & New Zealand Product Warranty Statements of Standard Warranty Conditions

Australian CustomersOur goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

New Zealand CustomersNothing herein contained shall be construed in any way as excluding or limiting your rights under the Consumer Guarantee Act 1993.

Our WarrantyThis product is also covered by the manufacturer’s warranty set out in this document (Our Warranty).

Our Warranty is for a period of twenty four (24) months from the date of purchase and for refrigeration appliances will have an additional thirty six (36) months after the first twenty four (24) months on the Sealed System (PARTS only) Compressor & condenser etc. The labour cost to replace these parts is the responsibility of the customer. This is in addition to (and does not exclude, restrict or modify) any rights or remedies to which you may already be entitled under the Australian Consumer Lawor the New Zealand Consumer Guarantee Act 1993 relating to this product. Our Warranty (which is subject to the conditions below) covers rectification free of charge of any fault arising from defective materials or components, or faulty workmanship. The product will be repaired or replaced at the option of Omega, and all costs of installation, removal, cartage, freight travelling expenses and insurance are to be paid by the customer. Our Warranty is subject to the following conditions:

  1. That the purchaser contact Omega prior to any product repair.
  2. That the purchaser carefully follows all instructions provided with the product and complies with all relevant electrical & plumbing regulations in their State when installing the product.
  3. That the purchaser carefully follows the instructions provided in the owner’s handbook relating to the proper use and care of the product and does not use the product for any purpose other than the DOMESTIC use for which it has been  designed. If the appliance is used in commercial applications or for rental purposes, Our Warranty is limited to a warranty of Twelve (12) months covering all parts with Three (3) months on any labour cost of service or repair.

Service AreaThe provision of service under Our Warranty is limited by the boundary / territory area of the nearest service centre. Travelling cost incurred for service outside this area is not covered by Our Warranty and service will incur commercial cost to be paid by the customer regulated by the number of kilometres travelled beyond the service area. These costs will be disclosed to you for acceptance by you prior to your claim being processed. Microwave ovens must be returned to your nearest Authorised Service Centre for repair as they are a carry in serviceable appliance.

What is Covered by our WarrantyDuring the warranty period, Omega or its authorised Service Centre will, at no extra charge, if your appliance is readily accessible without the need of special equipment and subject to the terms and conditions of this warranty, repair or replace any parts which it considers defective.

What is not Covered by our Warranty

  1. Products installed damaged or incomplete or not in compliance with the relevant electrical & plumbing regulations in their State.
  2. Normal wear and tear e.g. cleaning, light globes, filters etc.
  3. Failure resulting from power surges and electrical storms.
  4. Insect or vermin infestation.
  5. Unauthorised repairs or use of non-genuine Omega parts.
  6. Any failure caused by the product not being used in accordance with the instruction and the installation manual  provided with the product.
  7. Misuse or abuse, including failure to properly maintain or service.
  8. The clearing of blockages in pumps and hoses.
  9. Damage which occurs during delivery or installation.
  10. Claims to product surface coating due to liquid or solid spill-overs, accidental damage or damage caused from cleaning products not recommended by Omega.

How to Claim Our WarrantyWhile registering your warranty is not a requirement, for peace of mind you can register your warranty at omegaappliances.com.au.To make a claim under Warranty you will need to contact Omega in Australia or New Zealand by using the contact details below.If you are contacting Omega regarding any warranty claims and spare parts inquiries, please make sure you have the following information on hand:

  1. Product Name/Model Number
  2. Serial Number/s
  3. Purchase Date (as per invoice or proof of purchase)
  4. Purchased From
  5. Warranty Registration Number (if registered)

Disposal Information

  • Most of the packaging materials are recyclable. Please dispose of these materials through your local recycling depot or by placing them into appropriate collection containers.
  • If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal.

Further Information

For important information about your Omega Appliance such as warranty registration, manuals, features, and specifications please visit omegaappliances.com.au (if you are in Australia) and omegaappliances.co.nz (if you are in New Zealand) or contact our Customer Care team on the below email or phone numbers.

Registering Your Warranty

For peace of mind you can register your warranty at omegaappliances.com.au. Further information on the Warranty can be found at the end of this manual.

Contact Us

Our customer service team is here to help you with any question or concern.Both teams are on call Monday to Friday 8.30am to 5.00pm and of course you can always send an email at your convenience.

Australia Contact DetailsMonday to Friday 8.30am – 5.00pmEmail: [email protected]Phone: 1300 739 033

New Zealand Contact DetailsMonday to Friday 8.30am – 5.00pmEmail: [email protected]Phone: 09 415 6000

To stay up to date and find simple and easy recipes, follow us on our socials:facebook.com/omegaappliancesinstagram.com/omegaappliances_aus

Customer Support

Contact Us AustraliaOmega is a division of Shriro Australia Pty LtdPhone: 1300 739 033Email: [email protected]

Contact Us New ZealandOmega is a division of Monaco Corporation (member of Shriro)Phone: 09 415 6000Email: [email protected]

omegaappliance

report this ad

 @inegaappliance_aus

 

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, ,