Panasonic NN-TK714S Microwave Trim Kit Instruction Manual

Table of Contents

Installation InstructionsNotice d’installation

Cabinet	Trim kit
24″ (596 mm)	NN-TK714S

Read carefully and keep these installation instructions.© Panasonic Appliances Microwave Oven (Shanghai) Co., Ltd. 2014

CAUTION – Read and follow all instructions completely.

This Trim Kit is designed for use only with the Panasonic Microwave Oven listed in the table below, for installation into a cabinet.
The dimensions and ground clearance of the cabinet opening must be as indicated in Figure 1 on pages 6-8.
For safe use of your microwave oven, do not alter or modify any part of this kit or the microwave oven.
The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical Code, as well as any applicable local regulations. Refer also to the microwave operating instructions for other safety and electrical requirements.
The microwave oven must be unplugged from the wall receptacle before attempting the installation of this kit.
Save these instructions for local inspection and relocation of the microwave oven.
Use caution so that the power cord is not pinched during installation.
The diagrams in these instructions may vary from the actual unit and is only for reference.

Trim kit Panasonic Microwave Oven Models

NN-TK714S NN-SE7**SNN-SD7**SNN-SN7**SNN-ST7**S

Tools Needed: Measuring tape, pencil, Phillips screwdriver, Ø 2 mm ( 5/64″ ) drill

Put a piece of the tape on the top of the oven and put a piece of the tape on the left of the oven and left duct.

Lower Duct Installation

Aligning the base bracket assemblyPosition Base Bracket Assembly on a cabinet shelf. The front end of the Base Bracket Assembly should align flush with the front edge of the shelf.
Attaching the base bracket assembly