PATPET Pet Grooming Clipper 720 User Manual

QUICKSTARTPet Grooming Clipper 720

User Manual Before using please read the manual carefully and keep it properly for reference.

Product Diagram

Package Contents

Product Specification

How to Charge

1. Put the connecting plug into the clipper slot.
2. Put the adapter into the electrical outlet after confirming the clipper is switched off.

TURBO FunctionUnder power-on status, press TURBOthe clipper will speed up, and pressTURBO again to restore the initial speed.*Notice:

1.  It’s normal to generate some heat while charging and using the clipper.
2.  Please use original adapter to charge.

Blade Adjustment Method

• Blade adjustment method

1. To adjust upward, push the adjustment button directly to the required position.

To adjust downward, press the lock key down and then push the adjustment button to the required position.

Indicator instruction

• Indicator instruction when charging1. Start charging after confirming the clipper is switched off. indicators will light up one by one, showing the clipper is undercharging status.2. The battery is fully charged when all indicators are on without blinking
•  Indicator instruction when using1. When 100%-80% power is left, all indicators are on without blinking.2. When 80%-60% power is left, 1 indicator is off, the other 4 indicators are on without blinking.3. When 60%-40% power is left, 2 indicators are off, the other 3 indicators are on without blinking.4. When 40%-20% power is left, 3 indicators are off, the other 2 indicators are on without blinking.5. When less than 20% power is left, 4 indicators are off, only 1 indicator is on without blinking.6. When all lights go out, the clipper stops working, indicating the battery is fully discharged, please recharge it before using.*When fully charged, the clipper automatically cuts off power. The charging protection function starts to work to prevent damage from overcharging.*When the battery completely runs out, the overcharging protection function will be automatically activated to prevent the battery from over discharging and protect battery lifespan.

Mounting & Unmounting Comb

• Mounting the Comb Hold both sides, match the slot, and push up. (avoid losing or dropping)
• Unmounting the Comb Push away the locked part of the comb on both sides. (Do not press the front or back part to avoid damaging the comb)

Cleaning

1.  Before unloading the blade, make sure you have switched off the clipper. Use your thumb to remove the blade as shown above.
2. Use the brush to remove any remaining hair between the upper blade and the lower blade. Please do not take apart the spring of the blade in case it breaks down.
3. Use the brush to remove any remaining hair from the clipper.
4.  After cleaning the blade, add some lubricant between the upper blade and the lower blade. Otherwise, the blades’ edge may go dull, make a weird noise, give out heat, and lower the performance.
5. Replace the blade. You will hear a clicking sound when done correctly.

Cautions

1. Do not try to disassemble the clipper.
2. Do not clean the clipper with water. Keep it dry at all times.
3.  Do not use any corrosives such as alcohol, gasoline, etc. to clean the device.
4. Avoid charging it above acre and below Ot.*if the product is not used for a long time, please charge it once at least every three months.Disposal of BatteryPlease take the battery out before discarding the clipper and dispose of the battery in an environmentally friendly way.

Quality Moving the World

Shenzhen Patpet Technology Co., Ltdhttps://patpet.com/ Become a dealer: [email protected] After-service: [email protected] @PatpetDogCollar Youtube Video Guide

Made in Chana

report this ad

References

• 
  PATPET