Philips 5.1 Speakers SPA5128B User Manual

Table of Contents

Philips 5.1 Speakers SPA5128B User Manual

General information

Safety instructionsPlease read carefully the safety mark on the back side

This mark is intended to alert the user from the non isolated dangerous voltage within the product that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This mark is intended to alert the user for important operating and servicing instruction.

Warnings

Avoid sustained periods on high-volume use, and do not turn the volume to maximum level while using high output signal, such as Mobile Phone or DVD, etc., as this will cause distortion and may damage the loudspeaker cones.
Please switch off the system from the wall socket, when not in use.
Do not open the cover or back panel to avoid electrical shock or any other accidents. No user-serviceable parts are inside.
Only for indoor use.
Plug the system to the AC outlet with the right voltage marked on the back panel of the Subwoofer.
The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
The product shall not be exposed to dripping or splashing and that no objects filled with liquids such as vases, shall be placed on the product.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Attention should be drawn to the environmental aspects of battery disposal.

Care and safety informationAvoid high temperatures, moisture, water and dust

Apparatus should not be exposed to dripping or splashing of liquid.
Do not place any source of danger on the Subwoofer, and satellite (e.g. liquid filled objects lighted candles).
Do not install near heat sources.

Do not block any ventilation opening

Place the apparatus in a location with adequate ventilation to prevent internal heat build up. Allow at least 10cm (4 inches) of free space all around the apparatus for adequate ventilation.
At high volume the back cover of Subwoofer becomes hot. Do not touch it.

Care of the cabinet

Use a soft cloth slightly moistened to clean the cabinet. Do not use a solution containing alcohol, spirits, ammonia or abrasives.

Accessories

Connections

Top panel operation

Remote controls

Playing the Speakers and Subwoofer

Bluetooth Operating Instruction

Press SOURCE key from subwoofer’s front panel or remote control to Bluetooth mode;
When selected the Bluetooth mode, in display, “bt” will start blinking and hear an audio tone which indicate in Bluetooth pairing mode.
For pairing with mobile phone or other Bluetooth devices, search the device named “Philips SPA5128B” and pair it. Once paired, “bt” stops blinking and an audio tone will come up.
Press and hold “Play/Pause Button” for 3 seconds from remote control in order to force disconnect the Bluetooth connection.

Note: While using Bluetooth, if external call comes, then speaker system goes in mute mode in order to protect privacy of mobile phone user. Operation resumes once the call is disconnected.

Troubleshooting

Warning –Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy the problem by following hints mentioned in below table.

Warranty

This Philips 5.1 Multimedia Speaker System is warranted against any defect due to defective materials or workmanship for 12 months from the date of purchase, should a defect develop during the warranty, TPV Technology India PVT. LTD., affiliate of MMD Hong Kong Holding Limited undertake to repair the apparatus FREE OF CHARGE at any of its Authorized Service Center in India.

The warranty is not valid in case:

Proof of purchase is not accompanied with this warranty card.
The warranty card is not completed immediately after purchase.
The apparatus is not used according to this user manual.
Defects are caused due to improper or reckless use.
Any repairs are done by unauthorized personnel.
The serial number is tampered with.
Defects due to causes beyond control like lightning, abnormal voltage, acts of God or while in transit to the purchaser’s residence.