iPhonel2 Bluetooth Shutter
QUICK-START GUIDE
- To install onto grip, open the rubber flap located on top of the module.
- Next, align the screw with the grip’s1/4~-20 mount and install with the included hex key.
- Turn on the Bluetooth Shutter with the toggle switch, a green light will illuminate when powered on.
- To connect, locate LCP-BT-SHUTTER in your phone’s bluetooth device menu.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:— Reorient or relocate the receiving antenna.— Increase the separation between the equipment and receiver.–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.
report this adThe device has been evaluated to meet general RF exposure requirement.
[xyz-ips snippet=”download-snippet”]