A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:– Health and Safety at Work Legislation– Fire Precautions– Wiring Regulations– Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT use this appliance to store medical supplies.
DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
DONOT store products on top of the appliance.
Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.
Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance
Always switch off and disconnect the power supply to the unit before cleaning.
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
POLAR recommend that this appliance should be periodicallytested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
Caution Risk of Fire
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.
Warning: Donot use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
Warning: Do not damage the refrigerant circuit.
Warning: Donot use electrical appliances inside the food storage compartments of the appliance, unless they are the type recommended by the manufacturer.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.
Pack Contents
POLAR Countertop Refrigerated Merchandiser
Shelves x 2
Instruction manual
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging.Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 5cm clearance on the top.NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
Operation
Control Panel
The control panel is located below the doors on the rear of the appliance.
Turn On
Close the doors of the appliance.
Connect the appliance to a mains power supply.
Press the button to turn the light On or Off as required.
Setting the Operating Temperature
Press the SET button. The display will flash.
Press the or buttons to display the required temperature.
Press the SET button to store the temperature.
Table of Controller Parameters
The operating parameters of this appliance have been preset for optimum performance and to maximise the life of the appliance.
Display
Parameter
Preset Value
Range
E1
Lower set temperature
2°C
-20°C to 2°C
E2
Upper set temperature
6°C
2°C to 45°C
E3
Temperature buffer
4°C
1°C to 10°C
E4
Temperature buffer time delay
3 minutes
0 to 10 minutes
E5
Fixed parameter
0
DO NOT CHANGE
E6
Fixed parameter
00
DO NOT CHANGE
F1
Defrost period
25 minutes
1 to 60 minutes
F2
Defrost interval
6 hours
1 to 24 hours
F3
Defrost temperature
20°C
0°C to 22°C
F4
Centigrade/Fahrenheit
0°C
°C/°F
Should the parameter need adjusting:
Press and hold the SET button for six seconds. The “E1” parameter is displayed
Press the or buttons until the required value is displayed
Press the SET button to store the new value and cycle to the next parameter
NOTE: The controller times out after 10 seconds if no buttons are pressed
Manual Defrost:
Press and hold the button for 6 seconds to begin automatic defrost. The defrost light illuminates
Storing FoodTo get the best results from your POLAR appliance, follow these instructions:
Only store foodstuffs in the appliance when it has reached the correct operating temperature.
Do not place uncovered hot food or liquid inside the appliance.
Wrap or cover food where possible.
Do not obstruct the fans/vents inside the appliance.
Avoid opening the doors for prolonged periods of time.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
The doors can be removed for ease of cleaning.
Clean the interior of the appliance as often as possible.
Do not use abrasive cleaning agents. These can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
A POLAR agent or qualified technician must carry out repairs if required.
Replacing the Interior Lamp
WARNING: Allow the lamp to cool before replacing. The lamp remains hot immediately after use.
Turn Off and disconnect the appliance from the mains power supply.
Remove the lamp by twisting it from the lamp sockets.
Insert the new lamp and twist into place.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.POLAR recommend that a POLAR agent or qualified technician clean the condenser.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the Helpline or your POLAR dealer.
Fault
Probable Cause
Solution
The appliance is not working
The unit is not switched on
Check the unit is plugged in correctly and switched on
Plug or lead is damaged
Call POLAR agent or qualified Technician
Power supply
Check power supply
The appliance turns on, but the temperature is too high/ low
Too much ice on the condenser
Defrost the appliance
Condenser blocked with dust
Call POLAR or qualified technician
Doors are not shut properly
Check doors are shut and seals are not damaged
Appliance is located near a heat source, in the direct sunlight or air flow to the condenser is being interrupted
Move the refrigerator to a more suitable location
Ambient temperature is too high
Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored in the appliance
Remove any excessive hot foodstuffs or blockages to fan
Appliance is overloaded
Reduce the amount of food stored in the appliance
Factory default parameters adjusted
Call POLAR or qualified technician
The appliance is leaking water
The appliance is not properly levelled
Adjust the screw feet to level the appliance (if applicable)
The appliance is unusually loud
Loose screw/nut
Check and tighten all nuts and screws
The appliance has not been installed in a level or stable position
Check installation position and change if necessary
The display lamp does not illuminate
Lamp needs replacing
Call POLAR or qualified technician
Light not turned on
Ensure Light button has been pressed properly
Door does not shut
Dirt/obstacle in runners
Clean runners
Error code EE4
Restricted Airflow
Blocked Condenser
Increase airflow
Call POLAR agent or qualified Technician
Troubleshooting
Model
Voltage
Power
Current
Temperature Range
Capacity
Refrigerant
Dimensions H x W x D mm
Weight
CC611-A CC666-A
220-240V~ 50Hz
160W
1.4A
2-12°C
100L
R600a (48g)
675 x 682 x 450
39.1kg
Electrical Wiring
The plug is to be connected to a suitable mains socket.POLAR appliances are wired as follows:
Live wire (coloured brown) to terminal marked L
Neutral wire (coloured blue) to terminal marked N
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR.Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.