Top Loading Bottle CoolerInstruction manual
ModelCT330 / CT331 / CT332
Safety Tips
- Position on a flat, stable surface.
- A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product.
- Consult Local and National Standards to comply with the following:– Health and Safety at Work Legislation– BS EN Codes of Practice– Fire Precautions– IEE Wiring Regulations– Building Regulations
- DO NOT use jet/pressure washers to clean the appliance.
- DO NOT use the appliance outside.
- DO NOT use this appliance to store medical supplies.
- DO NOT stand or support yourself on the base, drawers, or doors.
- DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
- Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.
- Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.
- Always switch off and disconnect the power supply to the unit before cleaning.
- Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
- If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- POLAR recommends that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity, and Functional Testing.
- POLAR recommends that this product be connected to a circuit protected by an appropriate RCD (Residual Current Device).
Caution Risk of Fire
- Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
Warning: Keep all ventilation openings clear of obstruction. The unit should not be boxed in without adequate ventilation. - Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than thoserecommended by the manufacturer.
- Warning: Do not damage the refrigerant circuit.
- Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are the type recommended by the manufacturer.
Product Description
CT330 – Polar Top loading Bottle cooler – 935mm WidthCT331 – Polar Top loading Bottle cooler – 1255mm WidthCT332 – Polar Top loading Bottle cooler – 1634mm Width
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.
Pack Contents
The following is included:
- POLAR Refrigerator
- Instruction Manual
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.Should you find any damage as a result of transit, please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before the operation. If in doubt allow standing.
- Remove the appliance from the packaging.Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
- Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation. NEVER LOCATE NEXT TO OR NEAR A HEAT SOURCE.Note: Before using the appliance for the first time, clean the interior with soapy water.
- Level the appliance by adjusting the screw feet.
Operation
Control Panel
Set the Operating Temperature
- Hold the SET button for 3 seconds. The value of the current setpoint will be displayed.
- Press the or buttons to display the required temperature.
- Press the SET button to store the temperature.
Manual DefrostPress and hold the defrost button “aux” for 2 seconds to begin a manual defrost. The defrost light illuminates.
Cleaning, Care &Maintenance
Switch off and disconnect from the power supply before cleaning.
- Clean the interior of the appliance as often as possible.
- Do not use abrasive cleaning agents. These can leave harmful residues.
- Clean the door seal with warm soapy water.
- Always wipe dry after cleaning.
- Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
- Take care when cleaning the rear of the appliance. Sharp edges can be cut.
- A POLAR agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
- Periodically cleaning the condenser can extend the life of the appliance.
- POLAR recommend that a POLAR agent or qualified technician clean the condenser.
Troubleshooting
If your POLAR appliance develops a fault, please check the following table before making a call to the Helpline or your POLAR dealer.
|
Fault |
Probable Cause |
Solution |
| The appliance is not working | The unit is not switched on | Check the unit is plugged in correctly and switched on |
| Plug and lead are damaged | Call POLAR agent or qualified Technician | |
| Fuse in the plug has blown | Replace the fuse | |
| Power supply | Check power supply | |
| Internal wiring fault | Call POLAR agent or qualified Technician | |
| The appliance turns on, but the temperature is too high/low | Too much ice on the evaporator | Defrost the appliance |
| Condenser blocked with dust | Call POLAR agent or qualified Technician | |
| Doors are not shut properly | Check doors are shut and seals are not damaged | |
| The appliance is located near a heat source or airflow to the condenser is being interrupted | Move the refrigerator to a more suitable location | |
| Ambient temperature is too high | Increase ventilation or move the appliance to a cooler position | |
| Unsuitable foodstuffs are being stored in the appliance | Remove any excessive hot foodstuffs or blockages to the fan | |
| Appliance is overloaded | Reduce the amount of food stored in the appliance | |
| The appliance is leaking water | The appliance is not properly leveled | Adjust the screw feet to level the appliance (if applicable) |
| The discharge outlet is blocked | Clear the discharge outlet | |
| The movement of water to the drain is obstructed | Clear the floor of the appliance (if applicable) | |
| The water container is damaged | Call POLAR agent or qualified Technician | |
| The drip tray is overflowing | Empty the drip tray (if applicable) | |
| The appliance is unusually loud | Loose nut/screw | Check and tighten all nuts and screws |
| The appliance has not been installed in a level or stable position | Check installation position and change if necessary |
Technical Specifications
| Model | Voltage | Power | Current | TemperatureRange | Refrigerant | DimensionsH x W x D mm | Weight(kg) |
| CT330 | 230V 50Hz | 160W | 1.4A | 2°C ” 8°C | R600a 55g | 888 x 935 x 687 | 52.5 |
| CT331 | 230V 50Hz | 250W | 1.4A | 2°C,- 8°C | R600a 60g | 888 x 1255 x 687 | 67 |
| CT332 | 230V 50Hz | 250W | 1.4A | 2°C,,, 8°C | R600a 60g | 888 x 1634 x 687 | 78 |
Electrical Wiring
POLAR appliances are supplied with a 3 pin BS1363 plug and lead The plug is to be connected to a suitable mains socket.POLAR appliances are wired as follows:
- Live wire (colored brown) to the terminal marked L
- Neutral wire (colored blue) to terminal marked N
- Earth wire (colored green/yellow) to terminal marked E
This appliance must be earthed.If in doubt consult a qualified electrician.Electrical isolation points must be kept clear of any obstructions. In the event of any emergency, disconnection is required they must be readily accessible.
Disposal
EU regulations require refrigeration products to be disposed of by specialist companies who remove or recycle all gasses, metal, and plastic components.Consult your local waste collection authority regarding the disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.Alternatively, call the POLAR helpline for details of national disposal companies within the EU.
Compliance
 |
The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area. |
|
POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.POLAR products have been approved to carry the following symbol: |
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of POLAR.Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserves the right to change specifications without notice.
DECLARATION OF CONFORMITY
- Conformiteitsverklaring
|
Equipment Type |
Model |
|
| G-Series Top loading Bottle cooler – 935mm Width G-Series Top loading Bottle cooler – 1255mm Width G-Series Top loading Bottle cooler – 1634mm Width | CT330 (& -E -A)CT331 (& -E -A)CT332 (& -E -A) | |
| Application of Territory Legislation & Council Directives(s)Toepassing van Europese Richtlijn(en) | Machinery Directive 2006/42/EC
EN 60335-1:2012 +A11:2014 +A13:2017 EN 60335-2-89:2010 +A1:2016 +A2:2017 EN 62233:2008Electro-Magnetic Compatibility (EMC)Directive 2014/30/EU – recast of 2004/108/EC EN 55014-1:2017EN 55014-2:2015 EN 61000-3-2: 2014 EN 61000-3-3: 2013Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to Directive 2011/65/EU |
Electrical SafetyIEC 60335-1:2010 +A1:2013 +A2:2015 IEC 60335-2-89:2010 +A1:2012 +A2:2016Electromagnetic CompatibilityEN 55014-1:2017 EN 55014-2:2015 EN 61000-3-2: 2014 EN 61000-3-3: 2013 |
| Producer Name | Polar |
I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).
| Date | 3rd December 2020 | ||
| Signature |  |
 |
|
| Full Name | Ashley Hooper | Eoghan Donnellan | Josie Holt |
| Position | Technical & Quality Manager | Commercial Manager/ Importer | Commercial Manager/ Responsible Supplier |
| Producer Address | Fourth Way, Avonmouth, Bristol, BS11 8TB United Kingdom | 42 North Point Business Park New Mallow Road Cork Ireland | 15 Bagdally Road, Campbelltown NSW 2560 |
| UK | +44 (0)845 146 2887 |
| Eire | |
| NL | 040 — 2628080 |
| FR | 01 60 34 28 80 |
| BE-NL | 0800-29129 |
| BE-FR | 0800-29229 |
| DE | 0800 — 1860806 |
| IT | N/A |
| ES | 901-100 133 |
| PT | [email protected] |
http://www.polar-refrigerator.com/
CT330-CT332_ML_A5_v2_202012082020/12/8 17:36
report this ad
References
[xyz-ips snippet=”download-snippet”]