HG2000 potting benchASSEMBLY INSTRUCTIONS
IMPORTANTPlease read these instructions carefully before beginning to assemble this display. Save instructions for future reference.
PARTS IDENTIFICATION
TOOLS & EQUIPMENT REQUIRED
3/16″ hex wrench & 1/2″ open-end wrench are required to assemble this product.
ASSEMBLY INSTRUCTIONS
1. PLACE 30″ (SHORTER) LEGS INSIDE THE TABLETOP AS SHOWN.2. FASTEN TO THE TABLETOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. DO NOT TIGHTEN AT THIS TIME.
3. PLACE 43″ (LONGER) LEGS OUTSIDE OF TABLE TOP AS SHOWN.4. FASTEN TO TABLE TOP USING CAP SCREWS, FLAT WASHERS, LOCK WASHERS, AND HEX NUTS. DO NOT TIGHTEN AT THIS TIME.5. PLACE UPPER SHELF OVER TOPS OF 43″ LEGS AND FASTEN USING HARDWARE PROVIDED.6. STRAIGHTEN LEGS AND TIGHTEN ALL SCREWS SECURELY.
SAFETY GUIDELINES
Do not climb, sit on, or use this product as a ladder. Injuries may occur.Do not place or install electrical items on this product. Wet conditions are typical and electrical shock may occur.Do not place this product on a slope that exceeds 3 degrees.Do not move this display after product is in place. Damage to display and injuries may occur.
CARE & MAINTENANCE
To remove loose soil and debris, simply spray the soiled areas with a garden hose.Prior to storage, all surfaces of this product should be sprayed down with water and allowed to dry completely.
Limited Warranty
Poly-Tex, Inc. warrants its products to be free from defects in material and workmanship for a period of (1) year from date of invoice. This warranty is provided to the original purchaser of the product and is not transferable. Poly-Tex does not warrant parts not manufactured by Poly-Tex but does assign any transferable manufacturer or supplier warranties. Should any defect be found, full repair or replacement will be rendered to the customer at no cost following an inspection by a Poly-Tex representative and the return of the defective product to our Castle Rock, MN factory. Expenses for removal or reinstallation of defective products will not be covered by the warranty.
POLY-TEX SHALL NOT BE HELD RESPONSIBLE FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, OR FOR ANY DELAY IN PERFORMANCE OF THIS WARRANTY BEYOND OUR CONTROL. THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER IMPLIED, WRITTEN, OR ORAL INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
This warranty does not cover damage from customer abuse, misuse, improper installation, customer modifications, customer negligence in performing normal maintenance, damage resulting from acts of nature.
Contact informationPoly-Tex, Inc. PO Box 45827725 Danville Ave Castle Rock, MN 55010Toll free (800) 852-3443 Fax (651) 463-2479www.poly-tex.com
U.S. & Canada Toll-Free800-852-3443(651) 463-7009fax (651) 463-2479
References
[xyz-ips snippet=”download-snippet”]