Poolside Towel Tree 52505
We Make Water Fun!
770 Del Paso Road, Sacramento, CA 95834-0308
Assembly Instructions
- Fill Support Base with sand (preferred) or water using the fill hole. Insert the Base Cap.
- Connect the Bottom Post to the Top Post using the Connector. Tap lightly with a Rubber Mallet until both ends are fully seated on the center ring.
- Insert the Top Cap onto the end of the Top Post and tap lightly with a Rubber Mallet to fully seat.
- Insert the (6) End Caps onto each end of the (3) Cross Bars. Tap lightly with Rubber Mallet to fully seat (if necessary).
- Insert the (3) Cross Bars through the pre-drilled holes in the Top PVC Post. Position each Cross Bar at the “half-way” point or you may “off-set” them if desired.
- Insert the completed “Tree” into the Base and secure with Set Screw.
Recommended Tools
Questions or comments? call800.854.1492poolmaster.com[email protected]
Poolside Towel Tree 52505 Assembly Instructions – Poolside Towel Tree 52505 Assembly Instructions –
[xyz-ips snippet=”download-snippet”]