Racerstar airF7
Revision 08.08.2019
Technical data
Overview
airF7 combins the most useful features for FPV on one board.It using F722 MCU with ICM gyro for the best performance, the soft mount grommets plus speical designed filiter Circuit bring you the most “MPU6000 like” stability with ICM responding speed.
Highlight
- Speical designed filiter system “Good Dream”, will reduce most noise from power line
- Modular design, many PNP modules is coming, different BEC/BT/Receiver could be mounted on FC without ext. wires
- Highside video power switch function, cut off the VTX and camera power like real switch
- 6x Hardware UART + 1 independent I2C, every function one independent port, no more Multiplexing
- Airbot Configuration assistant supported, easier to config the functions for the FC
- Supported by EMUflight
Features
- STM32F722 MCU
- AB7456 OSD onboard
- 128mb(16MB) Flash for blackbox
- ICM Gyro
- 5V 3A BEC
- 9V 3A BEC(optional)
- BT module supported(optional)
- Receivers could be pluged and mounted direct on the FC(Frsky RXSR-FC and Cross fire RX)
- Highside video power switch
- Build in power filter system for main power and VTX/Camera power
- 6 UART
- 1x independent I2C(not need to share UART3)
- Independent 3.3v power source for senors and digital device
- “Strong pad” design, all solder pads has spare or through holes, no worry about ripped off solder pads
Resources
For No-Camera BEC version, short these green points will power the FC by VBAT
RaceStar AirF7 User Manual – RaceStar AirF7 User Manual –
[xyz-ips snippet=”download-snippet”]