110-0003 Power Storage DC 8.0
· ··· ·
· ··
·
· ·
·
·
·
·
DC cable –
DC cable +
Only an example!
In order to obtain the maximum yield from the solar system, it is possible to configure a dynamic power reduction. There is no additional equipment required for this configuration apart from the Power Sensor. The feed-in power is measured at the mains connection point and is only capped if the excess power exceeds the set value.
Changes to settings are only saved permanently if they are flashed to the inverter’s memory! It is therefore essential to press “FLASH” to confirm your settings changes. They will otherwise be lost when the inverter is switched off.
References
[xyz-ips snippet=”download-snippet”]