Thank you for buying your new Remington® product. Please read these instructions carefully and keep them safe. Remove all packaging before use.WARNING: This appliance is hot. Keep out of reach of children at all times.
IMPORTANT SAFEGUARDS
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance.Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.Do not use this appliance near bathtubs, showers, basins, or other vessels containing water.
When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.
For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom*.* Currently, the fitting in a bathroom of an electrical socket suitable or capable of operating the appliance is not permitted in the UK (see BS7671).
If the supply cord of this unit becomes damaged, discontinue use immediately and return the appliance to your nearest authorized Remington® service dealer for repair or replacement in order to avoid a hazard.
Always ensure the voltage to be used corresponds to the voltage stated on the unit before plugging the appliance into the mains socket.
Keep direct airflow away from eyes or other sensitive areas.
Do not allow any part of the appliance to touch the face, neck, or scalp.
During use, always ensure the inlet and outlet grilles are not blocked in any way as this will cause the unit to automatically stop. If this should occur, switch off and allow the unit to cool.
Keep the power plug and cord away from heated surfaces.
Do not leave the appliance unattended while plugged in.
Do not place the appliance on any soft furnishings.
Do not use attachments other than those we supply.
Do not set the appliance down while still on.
Do not twist or kink the cable, or wrap it around the appliance.
Do not use the appliance if it is damaged or malfunctions.
Check the cord regularly for any signs of damage.
This appliance is not intended for commercial or salon use.
Squeeze out excess moisture with a towel and comb through.
For best results, dry your hair as normal until it is about 70-80% dry.
Divide the hair into sections, style the lower layers first.
To fit the brush
Fit the brush head before you turn on the appliance.
Align the Symbol on the brush with the mark on the body (fig. A).
Rotate the brush until the symbol is aligned with the mark to secure (fig. B).
Speed and temperature settings
Plug your product into the main power supply.
To turn your air styler on, turn the speed selector switch to the 1 (low) or 2 (high) setting.
Your air styler has three temperature settings:1. High (): Thick and difficult to style hair2. Hydracare: Thin/fine, damaged, or bleached hair3. Cool (C): To set your style after styling
Use the heat selector switch to select the appropriate temperature for your hair type.
Creating volume
To dry your roots and add volume, place the brush underneath the section close to the roots and hold for a few seconds, lifting the hair as you dry.
Move the styler downward through the hair section.
Repeat this around the head.
Let the hair cool before further styling.
Creating shaped ends
To curl the ends in, place the brush underneath the section close to the ends and rotate the styler inwards allowing the hair to wrap around the barrel and hold for a few seconds.
To curl the ends out, place the brush on top of the section close to the ends and rotate the styler outwards allowing the hair to wrap around the barrel and hold for a fewseconds.
Repeat this around the head.
Let the hair cool before further styling.
Creating smooth, sleek hair
Starting at the roots, slowly brush through each section just as you would with a normal brush.
To add additional volume, tip your head upside down and brush the underneath of your hair.
Repeat this around the head.
Let the hair cool before further styling.
Hydracare setting
The Hydracare setting gently dries the hair at a lower temperature for healthier styling.
To activate select the Hydracare setting ( ) using the heat selector switch.
Cool setting
To set your style, use the cool setting. To operate move the temperature control switch to the C position.
STORAGE, CLEANING, AND MAINTENANCE
After use, turn the appliance off by turning the speed selector switch to the O position.
When finished unplug the appliance and allow it to cool before cleaning and storing away.
Wipe all surfaces with a damp cloth.
Don’t use harsh or abrasive cleaning agents or solvents.
To maintain peak product performance and to prolong motor life, it is important to regularly remove any dust and dirt from the inlet grille.
Clean the inlet grille with a cloth or soft brush.
RECYCLING
To avoid environmental and health problems due to hazardous substances, appliances, and rechargeable and non-rechargeable batteries marked with one of these symbols must not be disposed of with unsorted municipal waste. Always dispose of electrical and electronic products and, where applicable, rechargeable and non-rechargeable batteries, at an appropriate official recycling/ collection point.