RENEGADE Lightweight and Foldable
Kick Scooter User Manual
SAFETY WARNINGS
AN IMPORTANT MESSAGE TO PARENTS:This manual contains important information. For your child’s safety, it is your responsibility to review this information with your child and make sure that your child understands all warnings, cautions, instructions, and safety topics. We recommend that you periodically review and reinforce the information in this manual with younger riders and that you inspect and maintain your child’s scooter to ensure their safety.
GENERAL WARNINGScooter riding can be a hazardous activity. Scooters can and are intended to move and it is, therefore, possible to get into dangerous situations and/or lose control and/or fall. If such things occur you can be seriously injured or die. Like any other moving product, using a scooter can be a dangerous activity and may result in injury or death even when used with proper safety precautions. Use at your own risk and use common sense.
- Always wear safety equipment such as a helmet, knee pads, and elbow pads. Always wear a helmet when riding your scooter and keep the chinstrap securely buckled.
- Always wear shoes.
- Ride on smooth, paved surfaces away from motor vehicles.
- Avoid sharp bumps, drainage grates, and sudden surface changes. The scooter may suddenly stop.
- Avoid street and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction and visibility.
- Do not ride at night.
- Avoid excessive speed associated with downhill rides.
- Adults must assist children in the initial adjustment procedures to unfold the scooter, adjust the handlebar and steering to height, and finally to fold the scooter.
- Obey all local traffic and scootering laws and regulations. · Watch out for pedestrians.
- Do not exceed 220 pounds (100 kg).
- Do not allow children under 8 to use the scooter. Children under 9 should ride with adult supervision at all times. All children and preteens should ride with adult guidance at all times.
- Rider weight doesn’t necessarily mean a child’s size is appropriate to fit or maintain control of the scooter.
- A parent’s decision to allow his or her child to ride this product should be based on the child’s maturity, skill, and ability.
- Refer to the section on safety for additional warnings.
ACCEPTABLE RIDING PRACTICES AND CONDITIONSDirect parental supervision is required. Scooters are meant to be used only in a controlled environment free of potential traffic hazards and not on public streets. Do not allow your child to ride a scooter in any areas where vehicle traffic is present. The child must maintain a hold on the handlebars at all times. Never allow more than one child at a time to ride a scooter. Never use near steps, sloped driveways, hills, roadways, alleyways, or swimming pool areas, keep fingers and other body parts away from the product when folding or unfolding. Adults must not allow children to assist in folding or unfolding the scooter.
Do not ride a scooter in wet weather. Scooters are intended for use on solid, flat, clean, and dry surfaces such as pavement or level grounds without loose debris such as rocks or gravel. Wet, slick, or uneven and rough surfaces may impair traction and contribute to possible accidents. Do not ride a scooter in mud, ice, puddles, or water. Avoid excessive speeds that can be associated with downhill rides. Never risk damaging surfaces such as carpet or flooring by use of scooter indoors. Do not ride at night or when visibility is impaired.
PROPER RIDING ATTIREAlways ensure the child is wearing proper protective equipment such as an approved safety helmet. A helmet may be legally required by local law or regulation in your area. A child should always wear shoes, never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS FURTHER INCREASES THE RISK OF SERIOUS INJURY. USE AT YOUR OWN RISK AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION. USE CAUTION.
WARNINGSALWAYS INSPECT THE SCOOTER PRIOR TO RIDING. Properly inspecting and maintaining your scooter can reduce the risk of injury. Always inspect your scooter before riding and regularly maintain it. CHECK LOCAL LAWS REGARDING SCOOTER USE. Check local laws and regulations to see where and how You may use your street surfing scooter legally. in many states and local areas, scooter riders are required BY LAW to wear a helmet. Check local laws and regulations regarding laws governing helmet use and scooter operation in your area. The brake may get hot from continuous use. Do not touch after braking.
BEFORE YOU BEGIN
Remove contents from box. Remove the separators that protect the components during shipping. You will need to install the handlebars. locate and unpack the handlebars. Check to ensure that the upper clamp and screws are included.
Required Tools (included):3mm, 5mm & 6mm Allen Wrench (if using your own tools, we recommend the use of mechanic grade tools)
ASSEMBLY INSTRUCTIONS
SETUP AND USAGE INSTRUCTIONS
(1)
To adjust the height of the handlebars, unlock the steering tube by pulling outward on the quick-release lever. Slide the T-tube to the desired position and secure it by pushing inward on the quick-release lever.
(2)
The tension of the quick release clamping mechanism can be adjusted by tightening or loosening the Allen bolt. Be careful not to overtighten. You should always be able to open and close the quick-release lever by hand and the T-tube should telescope freely with the quick release open.
(3)
To unfold the scooter, pull the release lever downwards toward the deck while pulling upwards on the steering column.
(4)
Release the lever and continue to unfold the steering column upward. grip the handlebars and place one foot on the deck. Pull the handlebars up until the latch engages. Make sure the locking mechanism is secure in the open position before riding.
(5)
To fold the scooter push the handlebars forward lightly while pulling back on the release lever. if may help if you place one foot on the deck. When the release lever unlatches, pull back on the handlebars and continue folding your scooter until it latches.
WARNINGSDO NOT USE NON-HURTLE RENEGADE PRODUCTS WITH YOUR SCOOTER. HURTLE RENEGADE scooters have been built to certain design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork, and all other parts. Certain aftermarket products may or may not be compatible.
Failure to properly engage the quick-release clamps may cause the T-Bar to telescope up or down while riding, which may cause you to lose control and fall. With the quick-release properly adjusted and engaged the T-Bar will not move up or down in normal use.
Keep your fingers clear of the folding mechanism when folding or unfolding the scooter make sure others are standing clear.
Failure to properly install and tighten the handlebar t-tube steering tube clamp may cause the rider to lose control and fall. Assembly must be performed by an adult with mechanical experience. If you do not understand these instructions or the concept of “tightening securely”, seek the assistance of a qualified mechanic.
CHECK BEFORE RIDING
COLLAR CLAMPCheck that the collar clamp bolt is tightened securely. This item is tightened and quality inspected at the factory, after use, periodically check the tightness before riding.
WHEELS AND BEARINGSUnder normal circumstances and conditions, street surfing wheels and wheel bearings are maintenance-free. nonetheless, it is the responsibility of the owner or guardian to periodically inspect the wheel for wear and tear, the axle for proper tightness, and bearing for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine street surfing wheels. Worn tires/wheels/bearings are considered normal wear and tear and are not covered by the street surfing Warranty. Wheels other than genuine street surfing wheels may not be compatible with your street surfing scooter. The use of anything other than genuine street surfing replacement parts may affect your safety.
LOOSE PARTSCheck and secure all fasteners before every ride. Make sure that the steering tube clamps and handlebars spring buttons are locked properly in place before riding.
SAFETY GEARAlways wear proper protective equipment such as an approved safety helmet, elbow pads, and kneepads. Always wear shoes (lace-up shoes with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels.
SAFETY REMINDERS
CLEANING YOUR SCOOTERWipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based, or ammonia-based cleaners as they may damage or dissolve the plastic components or soften the decals or decal adhesive.
HOW TO RIDEPlace one foot on the deck, push forward with the other foot. steer. For enhanced cornering, lean slightly into the direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Practice applying the brake at various speeds and in an open area free from obstructions before riding around others.
BE CAREFUL!You will see people on TV and maybe even people you know doing tricks and stunts. These are people who have been practicing scooters for a very long time. Don’t try something until you are ready. Avoid steep inclines and don’t ride too fast–you can lose control and fall. skateboard parks are not designed for scooters. never ride in traffic or on the street and watch your surroundings for pedestrians, bikers, boarders, and skaters.
WARNING:Wheelies and other stunt-type riding reduces your ability to maneuver and control your scooter. Take the necessary precautions, such as wearing appropriate protective gear and practice in an area safe for stunt riding and free from obstructions.Maintain a hold on the handlebars at all times.Failure to follow these instructions may damage your vehicle and void your warranty.
LIMITED WARRANTY
If you ride your scooter in a manner that places large forces and stresses on the product, the scooter will not be covered under warranty. The scooter is designed to meet and exceed applicable safety standards, however, the forces exerted through extreme riding will cause premature wear to all parts.
The manufacturer warranties this product to be free of manufacturing defects for a period of 6 months from the date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or cables, or any damage, failure, or loss caused by improper assembly, maintenance, or storage.This Limited Warranty will be void if the product is ever:
- Used in a manner other than for recreation.
- Modified in any way.
- Rented.
The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product. HURTLE does not offer an extended warranty. If you have purchased an extended warranty, it must be honored by the store at which it was purchased. For your records, save your original sales receipt with this manual.
FEATURES & TECHNICAL SPECS
Features:
- Compact Kick Scooter
- Lightweight Alloy Deck
- Smooth Riding Wheels
- Comfortable T-Bar Handlebar
- Durable ABEC-7 Bearings
- T-bar Anodized Clamp Collar
- Includes Extended Standing Area for Pro-style Scooter Performance
- Stand Kick Scooter Design
- Adjustable T-Bar Handlebar Height
- Long-Lasting, Super Smooth Gliding Wheels
- Easy Maneuvering Lean-to-Steer Technology
- Lab Tested & Safety Certified
- Indoor/Outdoor Use
- Suitable for Teenagers and Adult, Beginner and Intermediate Riders
- Long Guard Rail to Stop Easily
- Mud Guard Front Wheel
- Extended up to 3 Heights
- Easy Folding Technology
- Foldable Handles
- Non-Slip Deck + Foot Stand
- Front Suspension
What’s in the Box:
- (1) Teens Scooter
- (1) Simple Tools for Assembly
- (1) Carry Strap
Technical Specs:
- Construction Material: 20% Steel + 80% Alloy
- Wheel Type / Wheel Material: PU Wheel
- Recommended Age: 8+
- Weight Capacity: Up to 220 lbs.
- Handlebar Height Setting: 33.1” x 35.8” x 38.6” -inches
- Wheel Size: 8” -inches
- Deck Size: 21.46” x 4.41” -inches
- Total Scooter Size (L x W x H): 33.1” x 12.3” x 38.6” -inches
- Product Weight: 4.4kgs
Questions? Issues?We are here to help!Email: [email protected]
References
[xyz-ips snippet=”download-snippet”]