Robit V7S Pro Robot Vacuum Cleaner Quick Operation Guide
Attention Before Use
Please neatly arrange desks, chairs and household appliances to prevent the robot getting stuck during cleaning.
Please do not stand in such narrow areas as doorways and aisles in case the robot fails to clean these areas.
The messy power cords, toys and other objects on the floor may entangle the robot, please kindly organize them.
Remove the white protective strip and the transparent protective film on the infrared front bumper before using. Otherwise, the robot may not work properly.
Charging the Robot
Preparation before charging
Before installing the charging base, remove the protective film on the charging Base, and wipe the installation ground till clean.
Place the charging base on a hard, level surface and against the wall. Remove objects within 3ft/ 1m of the left and right side and within 6ft/ 2m of the front charging base. Please do not place objects with strong reflecting surfaces around the charging base, such as mirrors.
Charging mode
*Turn on the side power switch on the robot (1 for power on, 0 for power off)*The green light turns on, the robot is activate.*When the orange light is breathing, the robot is charging.*When the green light is solid, the charging is completed.*You can charge your robot in the following ways:
- Charge the robot directly with a power adapter.
- Ensure the charging base is plugged in, and the robot in standby state, press the recharge button on the remote control or press the start-stop button of the robot for 3-5 seconds, the robot will return to charge automatically.
Start-cleaning
Press the start-stop button on the robot or 
on the remote control to start auto cleaning mode. During the auto cleaning process, the robot automatically perceives the missing area and then makes up intelligently.
During the working process, the robot will carry out route planning independently. Moved by human or remote control, the robot will redesign the route and clean up the area that have been cleaned.
In order to ensure efficiency, please do not move the robot at will.
The robot will stop for a short time in the process of working(calculating and planning the areas that need to be made up for cleaning or the path planning).Please wait patiently, and the time of pauses depends on the complexity of the indoor environment.
Turn on/ Turn off
When the robot is working, press the start-stop button 
or button on remote control, and then the robot will stop working.
If the robot in standby mode for more than 2 minutes, it will go into the inactive state. If you want to activate it again, press the start-stop button of the robot. It can also be activated by remote control.
After finished cleaning, turn the power switch in the side of the robot to “0”. The indicator goes off and robot is power off.
report this ad[This guide is not a substitute for instructions. Please refer to instructions if you need to learn further details and guidelines.]
[xyz-ips snippet=”download-snippet”]