RHTS Assembly Instructions
Thank you for purchasing these RHTS Wood Speaker Stands. Please read these instructions carefully before use. Make sure all parts are included. If any parts are missing please contact our technical helpline at 1-646-758-0144, Monday through Thursday, 9 am to 10 pm EST., and Fridays, 9 am to 3 pm EST.
Who Reads Manuals?Go to vimeo.com/000000000 or scan the OR code and watch a short video, which shows you how to set this item up and how to use it.
| Baseplate |  |
2 pcs |
| Small platform | |
2 pcs |
| Large platform | |
2 pcs |
| Stand body |  |
2 pcs |
| EVA isolation pads |  |
8 pcs |
| Phillips- head Screws |  |
16 pcs |
| Brass isolation spikes |  |
8 pcs |
| Rubber isolation spikes |  |
8 pcs |
| Cable clips |  |
4 pcs |
| Zip ties |  |
4 pcs |
Specifications
- Stand height: 36″
- Load capacity: 60 Lbs
- Large platform size: 11.8″x 9.25″
- Small platform size: 7.28″x 9.25″
- Base plate: 11.8″x 9.25″
- Stand weight: 12.5 lbs
Tools needed:
- Phillips-head screwdriver
Attach the base plate (E; flat side up) by aligning The screw holes with the stand body as in figure 1. Use four screws (F) to secure it in place. After attaching the base plate you may consider partially filling the stand body with sand for additional stability (see inset).
Select the appropriate size platform (A; there are two included). Align the holes on the platform with the edges of the stand body (B). Make sure that the beveled side of the platform (C) is facing up. Use four screws (D) to secure it in place.
Peel back the cover on the adhesive side of the EVA sound isolation pads (F) and place one on each corner of the top plate (G). These pads help to minimize resonance.
Now attach the isolation spikes to the bottom of the base plate. If needed, adjust the spike height to keep the stand level. To place the stand on a carpeted floor, use brass spikes. If you are placing the stand on wood, laminate, tile, or bare floor you should use the included rubber spikes.
The final step is to attach the cable clips to the back of the unit. Peel the cover off of the adhesive backing and place the clips in the desired locations. Once the clips are in place, slide a zip tie through the opening on the side of the clip (see inset H). Use the zip tie to secure the speaker cables (see inset I).2021 ROCKVILLE // The information presented is subject to change and or improvement without notice.
[xyz-ips snippet=”download-snippet”]