RunCam Racer MCK Edition User Manual

RunCam Racer MCK Edition

Joystick Control & UART Control Switchable

The top left corner of the screen will shortly display the current control mode. The default is Joystick control mode.

1. Short the two camera control pins
2. Then power on, camera will auto switch between the two modes
3. The mode can be saved after power off. After switching to the desired mode, please unplug the short-circuit cable.

UART Control works with Flight Controllers:

BetaFlight 3.3 or above / ButterFlight 3.4 or above / CleanFlight 2.2 or above / Kiss Flight RC36 or above

Joystick Control

UART Control

1.Flight controller wiringNote: Take UART3 for example

2.Betaflight 3.3 or above setting

Identifier	Configuration/MS	Serial Rx	Telemetry Output	Sensor Input	Peripherals
USB VCP	115200		Disabled	AUTO	Disabled	AUTO	Disabled	AUTO
UART1	115200		Disabled	AUTO	Disabled	AUTO	Disabled	AUTO
UART2	115200		Disabled	AUTO	Disabled	AUTO	Disabled	AUTO
UART3	115200		Disabled	AUTO	Disabled	AUTO	RunCam Device	AUTO
UART4	115200		Disabled	AUTO	Disabled	AUTO	Disabled	AUTO
UART5	115200		Disabled	AUTO	Disabled	AUTO	Disabled	AUTO

3.UART Control

Mode-2

Mode-1

• When connected, The buzzer on Flight Controller will beep for 3 times; When disconnected, The buzzer on Flight Controller will beep for 2 times only; If connected successfully, you can long press the up button to enter the OSD menu, right button to switch preset scenes, left button to calibrate voltage and down button to reset OSD.

Dimensions & Installation

OSD Menu

• QUICK SETTINGS

Quick settings:

• Long press UP button for three seconds to access to the OSD setting‘s screen
• Long press LEFT button for three seconds to calibrate the voltage. When the voltage text flashes, press UP/DOWN button to adjust it
• Long press DOWN button for six seconds to reset OSD settings to default
• Long press RIGHT button for three seconds to switch between the camera presets

OSD Menu

• CLR: clear the ID character;
• ALARM: low voltage warning value, smartly judge the warning value of the battery when it’s low; if set it manually, then it saves the manual preset value;
• Press the middle button to switch ON / OFF, then move to POS to enter the position adjustment.
• Sharp View: Turn on, it will increase the image details, but also noise.
• WIDESCREEN: Dynamic stretching to aspect ratio of 16:9 to match with screen in 16:9,the image center won’t change but the edge will be widened.

Camera Menu

• SETUP MENU
• LANGUAGE ( ENGLISH / DEUTSCH / FRANCAIS / PYCCKNN / PORTUGUES / ESPANOL / 中文 )
• FLIP ( OFF / H-FLIP / V-FLIP / HV-FLIP )
• BRIGHTNESS ( 128/ 0-255 )
• CONTRAST ( 138 / 0-255 )
• SHARPNESS ( 128 / 0-255 )
• HUE ( 90 / 0-180 )
• COLOR GAIN ( 138 / 0-255 )

Parameters