SAMSUNG VR05R503PWK PowerBot Essential with 2 in 1 Vacuum Cleaning Mopping Instruction Manual

Table of Contents

SAMSUNG VR05R503PWK Power Bot Essential with 
2 in 1 Vacuum Cleaning Mopping 
Instruction Manual

SAFETY INSTRUCTIONS

When using an electrical appliance, basis precautions should always be followed, including the following: READ ALL THE INSTRCUTIONS BEFORE USING (THIS APPLIANCE), Failure to follow the warnings and instructions may result in electric shock, fire and/ or serious injury. WARNING- To reduce the risk of fire, electric shock, or injury:

Do not use outdoors or on wet surfaces.
Do not allow to be used as a toy. Close attention is necessary when used by or near children, pets or plants.
Use only as described in this manual. Use only manufacture’s recommended attachments.
Do not use with damaged cord or plug. If appliance or docking station is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle charger, including charger plug, and charger terminals with wet hands.
Do not put any objects into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Do not use without dust bin and /or filters in place.
Prevent unintentional starting. Ensure the switch is the position before connecting to battery pack, picking up or carrying the appliance. Carrying the appliance with your finger on the switch or energizing appliance that have the switch on invites accidents.
Disconnect the battery pack from the appliance before making any adjustments, changing accessories, or storing appliance. Such preventive safety measures reduce the risk of starting the appliance accidentally.
Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when sued with another battery pack.
Use appliance only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
Do not use a battery pack or appliance that is damaged or modified. Damaged or modified battery may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
Do not expose a battery pack or appliance to fire or excessive temperature. Exposure to fire or temperature above 130°C may cause explosion.CAUTION
Do not use and store in extremely hot or cold environments ( below4°C or above 40°C). Please charge the robot in temperature above 4°C and below 40°C.
Follow all charging instructions and do not charge the battery pack or appliance outside of the temperature range specified in the instructions. Charging improperly or at temperatures outside of the specified range may damage the battery and increase the risk of fire.
Having servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.
Place the cords from other appliances out of the areas to be cleaned.
Do not operate the vacuum in a room where an infant or child is sleeping.
Do not operate the vacuum in an area where there are lit candies or fragile objects on the floor to be cleaned.
Do not operate the vacuum in a room that has lit candles on furniture that the vacuum may accidently hit or bump into.
Do not allow children to sit on the vacuum.
Do not use the vacuum on a wet surface.
Do not use the docking station if it is damaged.
Turn off the power switch before cleaning or maintaining the appliance.
The plug must be removed from the receptacle before cleaning or maintain the docking station.
Remove the appliance from the docking station and turn the power switch to the appliance before removing the battery for disposal of the appliance.
If the robot will not be used for a long time, fully charge the robot and power OFF for storage and unplug the charger.
For use only with VCA-RDS50 docking station.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Cleaning and user maintenance shall not be made by children without supervision.
Do not pour some water or liquid on the appliance. It could be increased the risk product breakaway or fire.
Do not use Powerboat near a heater or combustible materials. Do not use Powerboat near fire or flame such as a movable heater, a candlelight, a desk lamp, a fireplace etc. or in a place where combustible materials such as gasoline, alcohol, thinner etc. exist.
Make sure there are no dangerous objects around the Powerboat’s cleaning area to prevent collision and unplug any electric heaters or fans.
Do not use POWERBOT on black colored floors.– The POWERBOT may not be able to operate normally.

Product Introduction

Accessories may differ depending on the models

Product Operation

Caution

Do not use your robot on wet surfaces or surfaces with standing water. Before using the product on a rug with tasseled edges, please fold the rug edges under.
It may be necessary to place a physical barrier at the edge of a drop to stop the unit from falling over the edge.
Remove power cords and small objects from the floor that the robot could be obstructed by, and tidy up the area to be cleaned by putting furniture, such as chairs, in their proper place.
Please remove all the stuff on the floor, like slipper, cord, curation, etc. to make sure the robot works regularly.

Quick start guide

First use

For mopping system

Press the button on tank and remove the tank.
Fill the water.Cautiona. Do not input any chemical detergent and cleaner.b. Use only water.
Then insert the water tank assembly into the appliance.
Press “” and start mopping.

Remarka. It will take 5~10 minutes until the dry mop is wetting. ¹ Wet the mop with water before usingb. The amount of water can be controlled in the POWER bot-E App

Introduction of Remote Control

Docking: When in standby or working mode, appliance will return docking station for charging.
Direction: Controlling the moving direction by forward/left/right key
Start/Pause (Zigzag Cleaning): When in standby mode, appliance start working or pause with zigzag cleaning.
Spot cleaning: Start to cleaning by Spiral mode in certain zone
Edge cleaning: Cleaning by the edge of obstacle.
Auto cleaning: cleaning in the auto way.
Suction increase: Increasing the suction power.
Suction decrease: Decreasing the suction power.

Cautiona. please the battery in remote control before using: Take battery off if not used for a while.b. In case of safety, there’s no backward direction function.c. Please operate the remote control within 5m to appliance.

APP Guide Line (POWERbot-E)

App quick guide

Network access guide

Step 1Search “POWERbot-E” in APPLE App Store or Google Play Store, and download the App. Follow the instructions on the interface to register and login App.

NOTE: SmartThings is incompatible with tablets and some mobile devices. – Android 6.0 or later (at least 2GB of RAM) is recommended. iPad and some mobile devices may not be supported. – iOS 10.0 or later / iPhone 6 or later is supported. Visit Play Store or App Store to see if your mobile device is compatible with SmartThings. The supported features are subject to change without any prior notice.

Step 2Click “+ Add Device” on the interface and operate as instructed.

Step 3When first using, slow flickering of WiFi indicator light indicates that the cleaner gets into the state of network accessing configuration, now click “Next Step” on App and conduct network accessing config operation as per the prompts on the interface. Remarks: If WiFi indicator light doesn’t flicker, long press “ ” key for 3 seconds and release after a tick sound is heard.

Step 4

Once the network access is configured successfully, you can operate your cleaner by App.

CautionMake sure your phone is connected to home WiFi.

APP Guide line(SmartThings)

If you want to use your SmartThings App to control the robot.STEP 1. Finish the POWERbot-E App registration.STEP 2. Download the SmartThings App, search “SmartThings” in APPLE App store or Google Play Store and download.– You must sign in to a Samsung account before using the SmartThings app.– To set up a Samsung account, you can follow the directions provided by the SmartThings app.STEP 3. Register in the SmartThings App and login in.STEP 4. Link the SmartThings App and POWERbot-E App as below instruction, and then can control your robot via SmartThings App.

Product Maintenance

Cleaning

Check whether the side brush is damaged or has wrapped;
Clean the side brush with a cleaning tool or a rag;
If curl or deformation occurs, remove the side brush and put it in warm water for about 5 seconds;
When the side brush is damaged and cannot be used, please replace as soon as possible.

TROUBLE SHOOTING

In case of mies-function, please refer to the following table.

Open Source Announcement

The software included in this product contains open source software. The following URL http://opensource.samsung.com/opensource/VR_5000_M/seq/0to anyone in receipt of this information.