Segway F Series Ninebot KickScooter User Manual

Segway F Series Ninebot KickScooter

The manufacturer reserves the right to make changes to the product, release firmware updates, and update this manual at any time. Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials. You must install the app, activate your KickScooter, and obtain the latest updates and safety instructions.

Diagram

Dashboard & Power Button

Power Button: Press the button to turn on; press and hold the button for 3 seconds to turn off. When the KickScooter is on, press the button to turn on/off the headlight and the rear light, and press twice to switch between the speed modes.Speedometer: It displays the current speed of the scooter, as well as error codes.Please switch between metric and imperial units via the Segway-Ninebot app. How to switch: Tap the slide menu > Settings.Speed Mode: There are three modes available. The top speed is as follows:

Mode                                      Model F25 F30 F30S F40
ECO (Energy-saving mode) 9.3 mph (15 km/h) 9.3 mph (15 km/h) 9.3 mph (15 km/h)
D (Standard mode) 15.5 mph (25 km/h) 15.5 mph (25 km/h) 18.6 mph (30 km/h)
S (Sport mode) 15.5 mph (25 km/h) 15.5 mph (25 km/h) 18.6 mph (30 km/h)

Error Notification: It indicates that the scooter has detected an error.Temperature Warning: If the temperature warning is on, it indicates that the battery temperature has reached 131°F (55°C) or is below 32°F (0°C).* At this point, the vehicle cannot accelerate normally and may not be charged. Do not use until the temperature has reverted to the normal range.Bluetooth: It indicates that the scooter has been successfully connected to the mobile device.Battery Level: When the battery is at its full capacity, it will show 5 bars.* The battery power is very low when the first battery bar is red. Please charge your KickScooter immediately.

Specifications

  Item Parameter
 

 

Product

Name Ninebot KickScooter
Model F25
Length × Width × Height Approx. 45 × 18.9 × 45.7 in (1143 × 480 × 1160 mm)
Folded: Length × Width × Height Approx. 45 × 18.9 × 19.5 in (1143 × 480 × 495 mm)
Net Weight Approx. 32.4 lbs (14.7 kg)
 

Rider

Payload 66–220 lbs (30–100 kg)
Recommended Age 14+ years
Required Height 3’11”–6’6” (120–200 cm)
 

 

 

Machine

Max. Speed Approx. 15.5 mph (25 km/h)
Typical Range[1] Approx. 12.4 miles (20 km)
Max. Slope Approx. 12%
Traversable Terrain Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
Operating Temperature 14–104°F (-10–40°C)
Storage Temperature 14–122°F (-10–50°C)
IP Rating IPX5
Duration of Charging Approx. 3.5 h
 

 

 

Battery

Nominal Voltage 36 V
Max. Charging Voltage 42 V
Charging Temperature 32–104°F (0–40°C)
Nominal Capacity 5100 mAh
Nominal Energy 183 Wh
Battery Management System Over-heating, short circuit, over-current, over-discharge and over-charge protection
Motor Nominal Power 0.3 kW, 300 W
 

Charger

Output Power 0.07 kW, 70 W
Input Voltage 100–240 V~
Max. Output Voltage 42 V
Rated Output 41 V , 1.7 A
Features Brake Light LED Rear Light
Riding Modes Energy-saving mode, Standard mode and Sport mode
Tire Tire Pressure 40–45 psi
Tires 10-inch pneumatic tires.

[1] Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement.* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.

  Item Parameter
 

 

Product

Name Ninebot KickScooter
Model F30 F30S F40
Length × Width × Height Approx. 45 × 18.9 × 45.7 in (1143 × 480 × 1160 mm)
Folded: Length × Width × Height Approx. 45 × 18.9 × 19.5 in (1143 × 480 × 495 mm)
Net Weight Approx. 33.3 lbs (15.1 kg) Approx. 34.8 lbs (15.8 kg)
 

Rider

Payload 66–265 lbs (30–120 kg)
Recommended Age 14+ years
Required Height 3’11”–6’6” (120–200 cm)
 

 

 

Machine

Max. Speed Approx. 15.5 mph (25 km/h) Approx. 18.6 mph (30 km/h)
Typical Range[1] Approx. 18.6 miles (30 km) Approx. 24.9 miles (40 km)
Max. Slope Approx. 15% Approx. 20%
Traversable Terrain Asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
Operating Temperature 14–104°F (-10–40°C)
Storage Temperature 14–122°F (-10–50°C)
IP Rating IPX5
Duration of Charging Approx. 5 h Approx. 6.5 h
 

 

 

Battery

Nominal Voltage 36 V
Max. Charging Voltage 42 V
Charging Temperature 32–104°F (0–40°C)
Nominal Capacity 7650 mAh 10200 mAh
Nominal Energy 275 Wh 367 Wh
Battery Management System Over-heating, short circuit, over-current, over-discharge and over-charge protection
Motor Nominal Power 0.3 kW, 300 W 0.35 kW, 350 W
 

Charger

Output Power 0.07 kW, 70 W
Input Voltage 100–240 V~
Max. Output Voltage 42 V
Rated Output 41 V , 1.7 A
Features Brake Light LED Rear Light
Riding Modes Energy-saving mode, Standard mode and Sport mode
Tire Tire Pressure 40–45 psi
Tires 10-inch pneumatic tires.

[1] Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement.* Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc.

Certifications

This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.The battery complies with UN/DOT 38.3.The battery complies with ANSI/CAN/UL-2271.Federal Communications Commission (FCC) Compliance Statement for USAThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTEThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Industry Canada (IC) Compliance Statement for CanadaThis device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by