Shark HH200 Series UltraLight Corded Handheld Vacuum Owner’s Manual

Table of Contents

UltraLight Corded Handheld VacuumHH200 Series OWNER’S GUIDE

SAVE THESE INSTRUCTIONSREAD ALL INSTRUCTIONS BEFORE USE

IMPORTANT SAFETY INSTRUCTIONS

HOUSEHOLD USE ONLY

To reduce the risk of electric shock, this vacuum cleaner has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.DO NOT force into an outlet or try to modify to fit.

WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:GENERAL WARNINGSWhen using an electrical appliance, basic precautions should always be followed, including the following:

Inspect power cord and plug for any damage before use. DO NOT use a vacuum cleaner with a damaged cord or plug. Turn off all controls before plugging in or unplugging the vacuum cleaner.Store your vacuum cleaner with the power cord secured around the two cord hooks. To minimize the risk of power cord damage, do not allow themotorized brush roll to ingest the cord. If this occurs, immediately shut off the power to the vacuum and remove the cord.
Your vacuum cleaner may consist of a motorized nozzle, wand, hose, and/or vacuum pod. This device contains electrical connections, electricalwiring, and moving parts that potentially present risk to the user.
Use only identical replacement parts.
Carefully observe and follow the instructions provided below to avoid improper use of the appliance. DO NOT use the vacuum for any purpose other than those described in this manual.
Before use, carefully inspect all parts for any damage. DO NOT use if any parts are damaged.
The use of an extension cord is NOT recommended.
This vacuum cleaner contains no serviceable parts.USE WARNINGS
This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.Cleaning and user maintenance shall not be made by children. Keep the appliance and its cord out of reach of children. DO NOT allow the appliance to be used by children. DO NOT allow it to be used as a toy. Close supervision is necessary when used near children.
Always turn off the vacuum cleaner before connecting or disconnecting any motorized nozzles or other accessories.
DO NOT handle plug or vacuum cleaner with wet hands.
DO NOT use without filters in place.
Only use Shark® branded filters and accessories.
DO NOT damage the power cord:a)DO NOT pull or carry a vacuum cleaner by the cord or use the cord as a handle.b)DO NOT unplug by pulling on the cord. Grasp the plug, not the cord.c)DO NOT run the vacuum cleaner over the power cord, close a door on the cord, pull the cord around sharp corners, or leave the cord near heated surfaces.
DO NOT put any objects into nozzle or accessory openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
DO NOT use if nozzle or accessory airflow is restricted. If the air paths or the motorized floor nozzle become blocked, turn the vacuum cleaner off and unplug it from the electrical outlet. Remove all obstructions before you plug in and turn on the unit again.
Keep nozzle and all vacuum openings away from hair, face, fingers, uncovered feet, or loose clothing.
DO NOT use if the vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors, or dropped into water.
Use extra care when cleaning on stairs.
DO NOT leave the vacuum cleaner unattended while plugged in.
When powered on, keep the vacuum cleaner moving over the carpet surface at all times to avoid damaging the carpet fibers.
DO NOT place vacuum cleaners on unstable surfaces such as chairs or tables.
Your Shark® vacuum may not be designed to stand up on its own.When taking a break from cleaning, you may need to lean it against furniture or a wall or lay it flat on the floor. Using the vacuum for an application where the unit lacks stability may result in personal injury.
DO NOT use to pick up:a)Liquidsb)Large objectsc)Hard or sharp objects(glass, nails, screws, or coins)d)Large quantities of dust (drywall dust, fireplace ash, or embers).DO NOT use as an attachment to power tools for dust collection.e)Smoking or burning objects (hot coals, cigarette butts, or matches)f) Flammable or combustible materials (lighter fluid, gasoline, or kerosene)g)Toxic materials (chlorine bleach, ammonia, or drain cleaner)
DO NOT use in the following areas:a) Poorly lit areasb) Wet or damp surfacesc) Outdoor areasd) Spaces that are enclosed and may contain explosive or toxic fumes or vapors (lighter fluid, gasoline, kerosene, paint, paint thinners, mothproofing substances, or flammable dust)
Turn off all controls before plugging in or unplugging the vacuum.
Unplug from the electrical outlet when not in use and before any maintenance or cleaning.
Hand washes with water only.Washing with cleaning chemicals could damage the unit.
During cleaning or routine maintenance, DO NOT cut anything other than hair, fibers, or string wrapped around the brushroll.
Allow all filters to air-dry completely before replacing them in the vacuum to prevent liquid from being drawn into electric parts.
Make sure the dust cap and all filters are in place after routine maintenance.
If provided, secure the power cord around the two cord hooks during storage.

SETTINGS


ControlsThe control panel is located on top of the handheld vacuum.	Power ButtonPress the Power button to begin vacuuming.Press again to turn off the power.

CORD STORAGE

Cord WrapTo store the unit, wrap up the cord, leaving some slack. Use the hook-andloop fastener to hold the cord in place.

AVAILABLE ACCESSORIES

NOTE: Not all accessories come with all units. For a list of the accessories included with this model, see the top inside flap of the box. To order additional accessories, visit sharkaccessories.com.

A Crevice ToolThis slim tool is great for cleaning in tight spaces, between couch cushions, and in hard-to-reach areas. A longer crevice tool is available at sharkaccessories.com.B Upholstery ToolPicks up pet hair, dust, and large debris from mattresses, couches, curtains, and other delicate upholstered fabrics.C Dusting BrushThis brush dusts and cleans delicate surfaces.Great for use on fans, blinds, lampshades, and keyboards.D Pet Multi-ToolA single convertible tool for cleaning tough pet messes two ways: use the stiff bristle brush to clean stuck-on debris, or take off the bristles to reveal an upholstery tool perfect for removing stubborn pet hair and large piles of debris.E Duster Crevice ToolTwo cleaning tools in one. The crevice tool gives you extended reach to clean in tight spaces, while the soft brush is ideal for dusting delicate surfaces.F Anti-Allergen Dust BrushThis brush features nylon fiber bristles specifically designed for removing fine dust and allergen particles from the most delicate surfaces.GSelf-Cleaning Pet Power Brush Tackles pet hair and ground-in dirt from above-floor areas like carpeted stairs and upholstery, while actively removing hair wrap as it cleans.H Precision DusterThis flexible tube features a micro-duster crevice tool on the end for cleaning around delicate objects and in difficult-to-reach spots like car interiors and computer keyboards.I Accessory Bag (Large, 32 cm x 70 cm)This convenient accessory storage bag measures 32 cm x 70 cm. Smaller size available at sharkaccessories.com

MAINTENANCE

IMPORTANT: Unplug the vacuum before performing any maintenance.EMPTYING THE DUST CUPEmpty the dust cup each time you vacuum and periodically during cleaning when debris in the dust cup reaches the MAX fill line.


To remove the dust cap from the handheld vacuum, press the two Dust Cup Release buttons at the same time and slide out the dust cup.	Hold the dust cup over the trash. Press the Empty button and pull the dust cup open until it clicks and locks in the open position. Gently tap the cone-shaped screen inside the dust cup to knockdust and debris into the trash.

To reinstall, push the lid closed, then insert the front end of the dust cup into the handheld vacuum first, then the back end, until it clicks into place.

IMPORTANT: Unplug the vacuum before performing any maintenance.CLEANING FILTERSRegularly rinse and replace the filters to maintain your vacuum’s suction power.To prevent damage from cleaning chemicals, rinse filters with cold water only. Do not use soap. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electronic parts.


With the dust cup detached, press the Filter Access buttons on both sides of the back of the dust cap, then pull out the filter housing. Pull the foam filter out of the housing, then lift out the felt filter by the pull tab.The Pre-Motor Filters should be washed once a month.	To access the post-motor filter, press the Filter Access latch on the filter cover. Remove the cover and lift the out filter.The Post-Motor Filter should be washed once every 9 months.

REPLACEMENT FILTERS

Replacement Pre-Motor Filter KitXFFKHZ2000	Replacement Post-Motor FilterXPMFHZ2000

CHECKING FOR BLOCKAGES

Remove the dust cup and check all intake openings for debris or blockages.

TROUBLESHOOTING

The vacuum is not picking up debris. No suction or light suction.See the Maintenance section for more information.

Clear any blockages in the handheld vacuum or accessories, empty the dust cup and remove any hair from the cone-shaped screen, and clean filters regularly to maintain strong suction.

The vacuum turns off on its own.If your vacuum overheats, the thermostat will automatically turn off the motor. Perform the following steps to restart:

Turn the vacuum off and unplug it.
Empty dust cup and clean filters. See Emptying the Dust Cup and Cleaning Filters sections.
Check for blockages in a handheld vacuum, inlet openings, and accessories.
Allow the unit to cool for a minimum of 60 minutes.
Plugin a vacuum and turn it on.

The handheld vacuum is warm.Due to the strong suction power of the vacuum, it is normal for the area around the filter exhaust to become warm during and after use. Turn off the vacuum and wait 10 minutes for it to cool down. If it still feels warm, clean the pre-motor and post-motor filters. See Maintenance section for filter cleaning instructions.

FIVE (5) YEAR LIMITED WARRANTY

The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable.SharkNinja warrants that the unit shall be free from defects in material and workmanship for a period of five (5) years from the date of purchase when it is used under normal household conditions and maintained according to the requirements outlined in the Owner’s Guide, subject to the followingconditions and exclusions:What is covered by this warranty?

The original unit and/or non-wearable components deemed defective, in SharkNinja’s sole discretion, will be repaired or replaced up to five (5) years from the original purchase date.
In the event a replacement unit is issued, the warranty coverage ends six (6) months following the receipt date of the replacement unit or the remainder of the existing warranty, whichever is later. SharkNinja reserves the right to replace the unit with one of equal or greater value.

What is not covered by this warranty?

Normal wear and tear of wearable parts (such as foam filters, HEPA filters, pads, etc.), which require regular maintenance and/or replacement to ensure the proper functioning of your unit, are not covered by this warranty. Replacement parts are available for purchase at sharkaccessories.com.
Any unit that has been tampered with or used for commercial purposes.
Damage caused by misuse (e.g., vacuuming up water or other liquids), abuse, negligent handling, failure to perform required maintenance (e.g., not cleaning the filters), or damage due to mishandling in transit.
Consequential and incidental damages.
Defects caused by repair persons not authorized by SharkNinja. These defects include damages caused in the process of shipping, altering, or repairing the SharkNinja product (or any of its parts) when the repair is performed by a repair person not authorized by SharkNinja.
Products purchased, used, or operated outside North America.

How to get serviceIf your appliance fails to operate properly while in use under normal household conditions within the warranty period, visit sharkclean.com/support for product care and maintenance self-help. Our Customer Service Specialists are also available at 1-800-798-7398 to assist with product support and warranty service options, including the possibility of upgrading to our VIP warranty service options for select product categories.SharkNinja will cover the cost for the customer to send in the unit to us for repair or replacement. A fee of $25.95 (subject to change) will be charged when SharkNinja ships the repaired or replacement unit.How to initiate a warranty claimYou must call 1-800-798-7398 to initiate a warranty claim. You will need the receipt as proof of purchase.A Customer Service Specialist will provide you with return and packing instruction information.How state law appliesThis warranty gives you specific legal rights, and you also may have other rights that vary from state to state. Some states do not permit the exclusion or limitation of incidental or consequential damages, so the above may not apply to you.

REGISTER YOUR PURCHASEregisteryourshark.comScan QR code using a mobile device

http://registeryourshark.com

RECORD THIS INFORMATIONModel Number: ———————————-Date Code: —————————————-Date of Purchase: ——————————–(Keep receipt)Store of Purchase:——————————–

TECHNICAL SPECIFICATIONS

Voltage: 120V~, 60HzWatts: 635W

Benefits of registering your product and creating an account:

Get easier, faster product support and access to warranty information
Access troubleshooting and product care instructions
Be among the first to know about exclusive product promotions

TIP: The model number is on the rating label behind the dust cup.TIP: The date code is on one of the prongs of the power cord plug.

report this ad

PLEASE READ CAREFULLY AND KEEP IT FOR FUTURE REFERENCE.This Owner’s Guide is designed to help you get a complete understanding of your new Shark® UltraLight Corded Handheld Vacuum.SharkNinja Operating LLCUS: Needham, MA 02494CAN: Ville St-Laurent, QC H4S 1A71 800 798-7398sharkclean.comIllustrations may differ from actual products. We are constantly striving to improve our products; therefore the specifications contained herein are subject to change without notice.For SharkNinja U.S. Patent information, visit sharkninja.com/uspatents

References

[xyz-ips snippet=”download-snippet”]

Posted

2023-01-31

Shark

admin

Tags:

HH200 Series, Shark, UltraLight Corded Handheld Vacuum