Shark IZ1440H DuoClean PowerFins Cordless Vacuum with Self-Cleaning Brushroll User Guide

Table of Contents

DuoClean® PowerFins Cordless Vacuumwith Self-Cleaning Brushroll

QUICK START GUIDE

For questions, visit us online at sharkclean.com/supportIZ1440H

Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.

WHAT’S INSIDE:

A. Handheld VacuumB. DuoClean® PowerFins Floor NozzleC. MultiFLEX® WandD. Crevice ToolE. Dusting BrushF. ChargerG. HEPA Post-Motor Filter (Pre-Installed).

For additional parts and accessories, visit sharkclean.com

ASSEMBLY

POWER SETTINGS

Slide switch to the top to turn off the power. To begin vacuuming in Standard Mode, slide switch to the appropriate setting.

Bare Floor/Area RugsSlide switch to the middle. The brush roll spins slowly to clean bare floors and small area rugs.

CarpetSlide switch to the bottom. The brush roll spins faster to pick up debris below the surface of your carpets.

For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the trigger to go into Boost mode.NOTE: Select Carpet setting for stuck-on dirt and debris.

LI-ION BATTERY

In Use

Charging

NOTE: Full charge takes approximately 3 hours.

Battery Indicator Lights

NOTE: The battery comes partially charged. Charge fully before first use.

CHARGING

To charge, remove the handheld vacuum from the wand by pressing the Wand Release button and pulling up. Plug the charger into the charging port.

To put the vacuum in storage mode, press the MultiFLEX Lock Release button while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the battery.

Battery Runtime

MODE	MINUTES
Hand Vac	50
Bare Floor/ Standard Mode	34
Carpet Mode/ Standard Mode	23
Boost Mode (Hand Vac)	10

REACH ANYWHERE

Press the MultiFLEX® Lock Release button to lower the angle of the wand to increase your reach.

STORE ANYWHERE

Press the MultiFLEX Lock Release button and fold the handheld vacuum forward. To vacuum, lift up the handheld vacuum, until the wand locks in place.

EMPTYING THE DUST CUP

To empty the dust cup, first, disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up the handheld vacuum.
Position the dust cup over a trash bin and slide the lid release button forward.