Shenzhen Zhongde Hearing Technology LR01 Bluetooth Headset User Manual

BLUETOOTH HEADSETuser’s manualModel No:LRO1FCC ID: 2A5KK-LRO1

LR01 Bluetooth Headset

Read these safety instructions before using the device and store them for future reference.The LRO1 is a wireless headset that can be connected to the device to listen to music and receive calls while doing other activities, such as working out. Before using their mobile devices, make sure they are compatible with this device. Be careful not to wet the equipment when using it. If the equipment is damaged by water, it may malfunction. Avoid storing or using the device at temperatures lower than -15° C or higher than 55°C, which could shorten the headset or battery life.

Use headphones

1. Insert the headset into the acupoint of the headset charging box correctly. If the indicator light does not blink, connect the charging box to the charger and charge it for more than 10 minutes.
2. Close the charging box.
3. After opening the charging box and taking out the headset, the headset will automatically enter the pairing mode.
4. On the mobile device. enable Bluetooth function to search for LRO1 and connect it to the mobile device.

Ear pod touch function

Charging

You need to charge your device for 10 minutes before using it for the first time or after a long period of absence. When the battery of the earplug is low, it will issue “Please charge”, which can put the earphone into the charging box. When the earphone is charging, the red light will be displayed, and the light will be off if the charge is slow. Please close the charging case when storing or charging the headphones. The charging box is equipped with a built-in battery. Please use the Type-C cable to connect the charging box to another one, and then connect it to the computer or other charger for charging. When charging, the red light flashes, and the red light is always on when it is fully charged.

Warning

Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated without restriction.

Specifications

Accessories