Shure Microflex Wireless (MXW) User Guide

Shure Microflex Wireless (MXW) User Guide

MXW Quick Setup

MXW Wireless System

  • ① Wireless Microphones
  • ② System processor and wireless transceiver
  • ③ Microphone linking and charging station
  • ④ Analog output device with gigabit network switch
  • ⑤ Shielded Cat5e cables (not included)

Connect the System

Power On the Devices

Charge the Microphones

Note: the MXWNCS2 does not operate with gooseneck microphones.

Download the Shure Microflex Wireless Application

To discover and access devices on the network, download the Shure Microflex Wireless Application from .

View Devices on the Network

Initialize New Devices

New networked devices must be initialized with a passphrase. The same passphrase is assigned to each new device as part of initialization, and is required to access those devices. Double-click an initialized device to open it.

Select Devices for the Group

Link Microphones to the Group

Remove the Microphones

Microphone LEDs stop flashing when it is ready to use.

Test the Audio

MXW Help Links

Use the information at the following links to ensure the successful configuration and use of Microflex Wireless:

Safety Information

WARNING

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss (NIHL). Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

90 dB SPL 95 dB SPL 100 dB SPL 105 dB SPL
at 8 hours at 4 hours at 2 hours at 1 hour
110 dB SPL 115 dB SPL 120 dB SPL
at ½ hour at 15 minutes Avoid or damage may occur

SAFETY PRECAUTIONS

The possible results of incorrect use are marked by one of the two symbol “WARNING” and “CAUTION” depending on the imminence of the danger and the severity of the damage.

WARNING: Ignoring these warnings may cause severe injury or death as a result of incorrect operation.

CAUTION: Ignoring these cautions may cause moderate injury or property damage as a result of incorrect operation.

WARNING

  • Battery packs may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140°F (60°C), or incinerate.
  • Follow instructions from manufacturer
  • Only use Shure charger to recharge Shure rechargeable batteries
  • WARNING: Danger of explosion if battery incorrectly replaced. Replace only with same or equivalent type.
  • Never put batteries in mouth. If swallowed, contact your physician or local poison control center
  • Do not short circuit; may cause burns or catch fire
  • Do not charge or use battery packs other than Shure rechargeable batteries
  • Dispose of battery packs properly. Check with local vendor for proper disposal of used battery packs.
  • Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like
  • Do not immerse the battery in liquid such as water, beverages, or other fluids.
  • Do not attach or insert battery with polarity reversed.
  • Keep away from small children.
  • Do not use abnormal batteries.
  • Pack the battery securely for transport.

WARNING: Danger of explosion if incorrect battery replaced. Operate only with AA batteries.

Note: Use only with the included power supply or a Shure-approved equivalent.

Bodypack Microphone Transmitters

These transmitters have been tested and found to comply with international radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. These transmitters must not be co-located or operating in conjunction with any other antenna or transmitter.

Handheld Microphone TransmittersTabletop Boundary Microphone TransmittersTabletop Gooseneck Microphone Transmitters Wireless Access Point Transmitters

These mobile transmitters are intended for use at distances greater than 20 centimeters from the human body. These mobile transmitters are exempt from the testing requirements of international radiation exposure standards due to their proximity to the body of the user in their intended use case and their low power output. These mobile transmitters shall be placed or installed at least 20 cm from any person and must not be co-located or operating in conjunction with any other antenna or transmitter.

Important Product Information

The equipment is intended to be used in professional audio applications.EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable types may degrade EMC performance.

Changes or modifications not expressly approved by Shure Incorporated could  void your authority to operate this equipment.

Please follow your regional recycling scheme for batteries, packaging, and electronic waste.

Note: This device is not intended to be connected directly to a public internet network.

Information to the user 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Certifications

This device complies with FCC Part 15.

This device contains licence­exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence­exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Japanese Radio Law and Japanese Telecommunications Business Law Compliance. This device is granted pursuant to the Japanese Radio Law  and the Japanese Telecommunications Business Law. This device should not be modified (otherwise the granted designation number will become invalid). Conforms to electrical safety requirements based on IEC 60065. Meets essential requirements of the following European Directives:

  • WEEE Directive 2012/19/EU, as amended by 2008/34/EC
  • RoHS Directive EU 2015/863

Note: Please follow your regional recycling scheme for batteries and electronic waste

Hereby, Shure Incorporated declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of theEU declaration of conformity is available at the following internet address: http://www.shure.com/europe/compliance

Authorized European representative:Shure Europe GmbHHeadquarters Europe, Middle East & AfricaDepartment: EMEA ApprovalJakob-Dieffenbacher-Str. 1275031 Eppingen, GermanyPhone: +49-7262-92 49 0Fax: +49-7262-92 49 11 4Email: [email protected]

Authorized under the FCC verification provision per Part 15b.

Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)

Note: See the label located on the bottom side of the charger enclosure for the FCC marking, the CE marking, the RCM marking, and the electrical ratings.

Certified under FCC Part 15.

FCC: DD4MXW1, DD4MXW2, DD4MXW6, DD4MXW8, DD4MXWAPT4, DD4MXWAPT8.

Meets applicable requirements of RSS-213.

IC: 616A-MXW1, 616A-MXW2, 616A-MXW6, 616A-MXW8, 616A MXWAPT4, 616A-MXWAPT8.

Trademarks

report this ad

Audinate , the Audinate logo and Dante are trademarks of Audinate Pty Ltd. ®

 

References

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , ,