SIEMENS Extractor Hood Instruction Manual
Additional information on products, accessories, replacement parts and services can be found at www.siemens-home.com parts and in the Online shop www.siemens-home.com.bsh-group.com/eshops
Important safety information
Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners.
The appliance can only be used safely if it is correctly installed according to the safety instructions. The installer is responsible for ensuring that the appliance works perfectly at its installation location.
This appliance is intended for domestic use and the household environment only. The appliance is not intended for use outside. Do not leave the appliance unattended during operation. The manufacturer is not liable for damage which is caused by improper use or incorrect operation.This appliance is intended for use up to a maximum height of 2000 metres above sea level.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.Children must not play with, on, or around the appliance. Children must not clean the appliance or carry out general maintenance unless they are at least 8 years old and are being supervised.Keep children below the age of 8 years old at a safe distance from the appliance and power cable.Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport.This appliance is not intended for operation with an external clock timer or a remote control.
Danger of suffocation!Packaging material is dangerous to children. Never allow children to play with packaging material.
Room air-dependent heat-producing appliances (e.g. gas, oil, wood or coal-operated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e.g. a chimney). In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms – a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked back into the living space. Adequate incoming air must therefore always be ensured.An incoming/exhaust air wall box alone will not ensure compliance with the limit.Safe operation is possible only when the partial vacuum in the place where the heat-producing appliance is installed does not exceed 4 Pa (0.04 mbar). This can be achieved when the air needed for combustion is able to enter through openings that cannot be sealed, for example in doors, windows, incoming/ exhaust air wall boxes or by other technical means.
- Grease deposits in the grease filter may catch fire. Replace the grease filter at least every two months. Never operate the appliance without the grease filter.
- Grease Risk of fire! deposits in the grease filter may catch fire. Never work with naked flames close to the appliance (e.g. flambéing). Do not install the appliance near a heat producing appliance for solid fuel (e.g. wood or coal) unless a closed, non-removable cover is available. There must be no flying sparks.
- Hot Risk of fire! oil and fat can ignite very quickly. Never leave hot fat or oil unattended. Never use water to put out burning oil or fat. Switch off the hotplate. Extinguish flames carefully using a lid, fire blanket or something similar.
- When gas burners are in operation without any cookware placed on them, they can build up a lot of heat. A ventilation appliance installed above the cooker may become damaged or catch fire. Only operate the gas burners with cookware on them.
- Operating Risk of fire! several gas burners at the same time gives rise to a great deal of heat. A ventilation appliance installed above the cooker may become damaged or catch fire. Never operate two gas burners simultaneously on the highest flame for longer than 15 minutes. One large burner of more than 5 kW (wok) is equivalent to the power of two gas burners.
- Components inside the appliance may have sharp edges. Wear protective gloves.
- Items Risk of injury! placed on the appliance may fall down. Do not place any objects on the appliance.
- The Risk of injury! light emitted by LED lights is very dazzling, and can damage the eyes (risk group 1). Do not look directly into the switched on LED lights for longer than 100 seconds.
- A defective appliance may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service.
- Incorrect Risk of electric shock! repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service.
- Do Risk of electric shock! not use any high-pressure cleaners or steam cleaners, which can result in an electric shock.
Causes of damageCaution!Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage.
Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth.
Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only. Do not use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning agents. Never use strong and abrasive cleaning agents.
Risk of damage from returning condensate. Install the exhaust duct in such a way that it falls away from the appliance slightly (1° slope).
Environmental protection
Your new appliance is particularly energy-efficient. Here you can find tips on how to save even more energy when using the appliance, and how to dispose of your appliance properly.
Saving energy
- During cooking, ensure that there is a sufficient supply of air so that the extractor hood can work efficiently and with a low level of operating noise.
- Adjust the fan speed to the intensity of the cooking fumes. Only use intensive mode where this is required. A lower fan speed means that less energy is consumed.
- If there are intensive cooking fumes, select a higher fan speed in good time. If cooking fumes have already spread in the kitchen, the extractor hood must be operated for longer.
- Switch off the extractor hood if you no longer require it.
- Switch off the lighting if you no longer require it.
- Clean and, if required, replace the filter at regular intervals in order to increase the effectiveness of the ventilation system and to prevent the risk of fire.
Environmentally-friendly disposal
Operating mode
This appliance can be used in air extraction mode.
Exhaust air mode
Note: The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
Before conveying the exhaust air into a non-functioning smoke or exhaust gas flue, obtain the consent of the heating engineer responsible.
Operating the appliance
Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes.
Controls
In the control panel, use the buttons to set the appliance’s different functions.
Control panel
Extractor hood
Switching on or offPress the button.
Note: It can take up to 25 seconds for the backflow preventer valve to open fully and for the appliance to reach its full capacity.
Lighting
The lighting will work even if the extractor hood is switched off.
Switching on or offPress the B button.
Cleaning and maintenance
Penetrating moisture may result in an electric shock. Clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.
Do not use any high-pressure cleaners or steam cleaners, which can result in an electric shock.
Cleaning agentsTo ensure that the different surfaces are not damaged by using the wrong cleaning agent, observe the information in the table. Do not use any of the following:
- Harsh or abrasive cleaning agents,
- Cleaning agents with a high alcohol content,
- Hard scouring pads or cleaning sponges,
- High-pressure cleaners or steam cleaners.Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the cleaning agents.
Removing and installing the filter
The filter must be serviced regularly in order to guarantee efficient filtration of odours and grease.
Metal grease filterThe metal grease filters must be cleaned every 100 operating hours or at least every two months.
Removing metal grease filterThe metal grease filters filter the grease out of kitchen steam. To keep them in good working order, the filters should be cleaned at least every two months.
- Open the lock on the metal grease filters and remove the filters from the retainer.Notes• When you do this, take hold of the metal grease filters from underneath with your other hand. Make sure that the metal grease filters do not fall and damage the hob.• Fat may accumulate in the bottom of the metal grease filters. Hold the filters level to prevent fat from dripping out.
- Clean the metal grease filters.
- Clean the inside of the appliance.
Cleaning the metal mesh grease filtersNotes
- Do not use any aggressive, acidic or alkaline cleaning agents.
- When cleaning the metal mesh grease filters, also clean theholder for the metal mesh grease filters in the appliance using a damp cloth.
- The metal mesh grease filters can be cleaned in the dishwasher or by hand.
By hand:Note: You can use a special grease solvent for stubborn dirt. It can be ordered via the Online Shop.
- Soak the metal mesh grease filters in a hot soapy solution.
- Clean the filters with a brush and then rinse them thoroughly.
- Leave the metal mesh grease filters to drain.
In the dishwasher:Note: If the metal mesh grease filters are cleaned in the dishwasher, slight discolouration may occur. This has no effect on the function of the metal mesh grease filters.
- Do not clean heavily soiled metal mesh grease filters together with utensils.
- Place the metal mesh grease filters loosely in the dishwasher. The metal mesh grease filters must not be wedged in.
Installing the metal mesh grease filter
- Insert metal grease filter.
- Fold up metal grease filter and engage the lock.
Note: Make sure that the filter lock engages properly.
Trouble shooting
Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service.
LED lights
Defective LED lights may be replaced by the manufacturer, their after-sales service or a qualified technician (electrician) only.
Fault table
After-sales service
Our after-sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician.
When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice. The rating plate with these numbers can be found inside the appliance (remove the metal mesh grease filter to gain access).
You can make a note of the numbers of your appliance and the telephone number of the after-sales service in the space below to save time should it be required.
E no._____________________
FD no._______________________
After-sales service_____________________
Please be aware that a visit by an after-sales engineer will be charged if a problem turns out to be the result of operator error, even during the warranty period.Please find the contact data of all countries in the enclosed customer service list.
To book an engineer visit and product adviceGB 0344 892 8999Calls charged at local or mobile rate.
IE 01450 2655 0.03 per minute at peak. Off peak 0.0088 per minute.
Rely on the professionalism of the manufacturer. You can therefore be sure that the repair is carried out by trained service technicians who carry original spare parts for your appliances.
Special accessories
(not supplied)Note: Follow the installation instructions supplied with the accessories.
AccessoryBackboard, 60 cmBackboard, 90 cm
Order numberLZ50660LZ50960
BSH Hausgeräte GmbH Carl-Wery-Straße 34, 81739 München, GERMANYssiieemmeennss–hhoommee..bcoshm-group.comManufactured by BSH Hausgerate GmbH under Trademark License of Siemens AG
References
[xyz-ips snippet=”download-snippet”]