Skullcandy IndyEvo / Indy XT Evo User Manual
User Guide
Auto Pair Mode
Pairing mode
Auto Power ON
Auto Power OFF
Charge Earbuds
Charge Case
Pairing Mode
Off mode
Pair New Device
“Indy Evo”
Power – ON
Left side 01 and Right side 02
Power – OFF
Left side 01 and Right side 02
Play Pause
Track Forward
Track Back
Volume Up
Right Side 02
Volume Down
Right Side 01
Answer/End
Left side 01 and Right side 02
Activate Voice Assistant
Left side 01 and Right side 02
Clear Paired Device
Reset Device
Left side 01 and Right side 02 “Off mode”
Download The Tile App
Pair Tile
3 EQ Modes
Change equalizer modes
Music, Movies, and Podcast
Ambient Mode
Question Visit: www.skullcandy.com
Description
- Speaker Driver: 6mm,
- Impedance: 32 Ohms, THD <3%@1KHz,
- Voltage Regulation: 5V, 500mA, Bluetooth® 5.0,
- Frequency Band: 2402MHz — 2480MHz,
- Maximum Power: 10mw,
- Weight: 63.5g.
Skullcandy, and other marks are registered trademarks of skullcandy, Inc. All rights reserved.
Maximum operating temperature 45 °C.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
ISED Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:(1 )This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device.
ISED SAR Compliance Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body.
Americas
Skullcandy, Inc.6301 N Landmark Dr. Park City, UT 84098 U.S.A.Skullcandy.com
Canada
Skullcandy Canada ULC329 Railway St. Unit 205Vancouver BC V6A 1A4 CanadaSkullcandy.ca
Europe
Skullcandy Europe BVPostbus 4255500AK Veldhoven NederlandSkuncandy.eu
Mexico
Skullcandy Mexico S de RL de CVAtistoteles 218Polanco IV Seccion, Miguel Hidalgo11550, Mexico City, MexicoSkulicandy.m
Japan
Skullcandy Japan150-0001Skullcandy.jp
Contains Li-ion battery. Battery must be recycled or disposed of properly.
Hardware Version: V1.4Software Version: V3.0
R-C-Sku-S2IVW 018-190429
[xyz-ips snippet=”download-snippet”]