SOUNDSTREAM SR1-3000 1-Channel Amplifier Owner’s Manual

SOUNDSTREAM SR1-3000 1-Channel Amplifier

Panel Definition

SR1-1500
SR1-3000

Features & Functions:

Input Connection:

Output connection:

Again, high current barrier strip terminals are provide for connection to the loud speaker system.Connect the subwoofer speaker+ lead to the + terminal and the subwoofer spaker­lead to the terminal.Note: Mono mode is designed for 2-8 ohm loads. If connecting two subwoofer speakers, the unit will not support a 1 ohm load.Connect two Subwoofer Systems:Connect the two pairs of output terminals to corresponding subwoofer speakers:

Output connection:

Connect one Subwoofer System:

1st speaker connection:

2nd speaker connection:

TROUBLE SHOOTING

No Audio

  • Low or no remote turn-on voltage: check remote connections at the amplifier and source unit.
  • Blown amplifier fuse: replace with a new fast-blow fuse (same rating).
  • Power wires not connected: check battery and ground wiring at the amplifier and check the battery connections.
  • Speaker leads shorted: check speaker continuity to ground; it should not show a common ground.
  • Speakers not connected or are blown: check speaker connections at the amplifier; measure coil impedance.

Distorted audio 

  • Gain is not properly set or the speaker cones are damaged.
  • Review the instructions for setting the gain. Inspect each speaker cone for signs of damage, such as a frozen cone, burning smell, etc.

[xyz-ips snippet=”download-snippet”]


Posted

in

by