The Brighter Choice
SELECTABLE GIMBALSLIM LED LIGHTSInstall Guide and Manual
COMPONENTS
EASY INSTALLATION
- Turn off a circuit breaker that provides power to the light switch for the recessed lights.
- Cut a hole in the ceiling in the desired location according to the dimension indicated.• 3” Housing: 3.35”• 4” Housing: 4.33”• 6” Housing: 6.38”
- Run an electrical wire from the power source (switch) through the mounting hole.
- Open the junction box and remove the appropriate knockout on the side plate.
- Connect the supply wires to the junction box wires using the wire nuts provided.• White to white• Black to black
- Tuck the connected wires inside the junction box and close the cover.
- Connect the junction box to the gimbal. Tighten the connector by hand.
- Turn on the power and test light.
- BEFORE PROCEEDING:On the back of the j-box, slide the CCT Selection Switch to choose from five color temperatures (2700K, 3000K, 3500K, 4000K, 5000K). Try each CCT to determine which suits your room.• Light will use the preferred setting whenever you turn on the switch.• Turn off the light switch and continue to install.
- Insert junction box through the hole in the ceiling.• New construction applications: Hardwire box shall be secured to studs, joists, or similar fixed structural units.• Remodel applications: Does not require the hardwire box to be firmly secured after the mounting platesstuds, joists, or structural units have been concealed.
- Adjust flexible optic position to aim the light beam where needed. Gimbal rotates 360° and tilts 35°.
- Push up the spring clips to insert the luminaire in the opening in the ceiling.
- Turn on the circuit breaker and test the light.
SPECIFICATIONS
| Product Size | 3‘ | 4′ | 6″ |
| Voltage | 120V | ||
| Wattage | 7W | 12W | 14W |
| Lumens | 500 | 750 | 900 |
| Weight | 0.37 lbs | 0.44 lbs | 0.64 lbs |
| Suitable for Locations Ingress | Damp | ||
| Warranty | 7 years |
WARNINGTo reduce the risk of fire, electric shock or injury to people:
- This product should be installed in accordance with the applicable installationcode by a person familiar with the construction and operation of the product and the hazards involved.
- Abide by related regional and local laws or regulations.
- Do not alter, relocate or remove wiring.
- Do not make or alter any open holes in an enclosure or electrical components.
- Proper grounding is required to ensure safety.
- Check for damage during shipping prior to installation. If the product is damaged,do not use it.
- Turn off the switch and circuit breaker before installing this LED light.
- Use safety precautions. Safety eyeglasses and gloves are recommended.
- Please review instructions carefully before proceeding.
[xyz-ips snippet=”download-snippet”]