Swiss Madison – well made forever Wall-Hung Toilet Installation Guide

Table of Contents

@SwissMadison#WellMadeForever

Inspect toilet to ensure no damages have occurred while in shipping.
Observe all plumbing and building codes in accordance with your state and local requirements.
All dimensions are nominal! Be sure to measure your toilet prior to installation.
The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss Madison products by hiring a licensed professional.
Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for your protection.
Two people are recommended to handle and install this product as it is fragile.

If you have any questions or concerns please contact us:1-434-623-4766[email protected]

Install Tank Carrier System
- Before toilet bowl installation, a wood frame and commercial or residential tank system is required.
- Install according to manufacturer’s instructions.
Dry Fit Outlet Pipe and Inlet Pipe
- Fully insert straight tube into cistern flushing outlet then connect pipe into discharge outlet.
- Draw lines to mark the finished wall location on each pipe as pictured below.
Determine Pipe Size
- Apply lubricant on rubber washers of straight tube and connecting pipe, then insert into holes.
- Draw lines on pipes as pictured below.
Cut Pipes
- Measure the distance between both marked lines on pipe. Take measured distance, deduct from bald end of pipe and cut pipes as shown below.
- After cutting, take a file and remove all burrs. Try and bevel pipe edge.L1: The distance between the two lines on the straight tube.L2: The distance between the two lines on the connecting pipe.
Mount Toilet Bowl
- Apply lubricant to the joint surface on straight tube and connecting pipe.
- Mount the toilet bowl to the wall.
Level and Attach Bowl
- Attach bowl using the washers and bolts, make sure the bowl is level, then cover with included cap.
- Fill any gaps with cement or sealant.

Dissassemble
- Disassemble the cover cap and the hinge.
Construct Hinges
- Insert screw and nut into the hole on the hinge.
- Attach blind hole screw fixing to the bottom of screw.
Attach Hinges
- Insert hinges with blind hole screw fixings attached into holes on toilet bowl.
- Lightly tighten hinges with a screwdriver too allow for later adjustment.
Adjust and Cover Hinges
- Be sure the hinge is all the way forward for proper seat fitting.
- Place the covers onto the hinges.
Adjust and Attach Seat
- Align seat to the hinges then firmly tighten the hinges.
- Attach seat to the secure hinges.
- Adjust seat to align to the bowl.

To remove, push middle button until you hear a “click”, then pull straight up.
To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.