Swissonic HDMI-SDI 3G Converter Full-HD User Guide

Table of Contents

Swissonic HDMI-SDI 3G Converter Full-HD

Safety instructions

Intended use This device is used to convert HDMI signals to SDI format. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.

The danger for children

Ensures that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts from the product. They could swallow the pieces and choke!

Where to use the product Never use the product

in conditions of extreme temperature or humidity
in extremely dusty or dirty areas
in locations where the unit can become wet
in locations with high levels of electrostatic or magnetic radiation

General handling

To prevent damage, never use force when handling the product.
Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use liquid cleaners such as benzene, thinners, or flammable cleaning agents.

Features

Converter from HDMI to SDI signals with up to
3G-SDI connections
Detects SD and HD formats automatically
Connections: Input: HDMI type AOutput: 2 × SDI
Impedance:75 ohms
SDI formats:SD-SDI, HD-SDI, 3G-SDI
Supported input resolutions: 480i @ 60 Hz, 576i @ 50 Hz, 720p @ 50 Hz, 720p @ 60 Hz, 1080i @ 50 Hz, 1080i @ 60 Hz, 1080p @ 24 Hz / @ 25 Hz / @ 30 Hz / @ 50 Hz /@ 60 Hz
Dimensions (W × H × D): 121 mm × 66 mm × 26 mm
Weight:0.25 kg
Temperature range: 0 °C – 40 ° C, relative humidity 50 %, non-condensing
Delivery including international power supply (5 V )

Operating elements

(1) Connection for power supply(2) Pilot light(3) HDMI IN HDMI input(4) SDI OUT 1 SDI output 1(5) SDI OUT 2 SDI output 2

Using the product

Connect the HDMI output of the desired device to the HDMI IN socket using a suitable HDMI
Connect the input of a suitable SDI device to the SDI 1 output. If necessary, proceed in the same way with output SDI 2.
Connect the device to a properly wired mains socket using the power supply supplied. The device is immediately ready for use.
If the device detects a supported HDMI format at the input, the power indicator lights up blue, otherwise red.
If the resolution of the input signal matches one of the supported resolutions of the SDI device connected to the output, the signal is output via the SDI 1 output and can be split for simultaneous output to a device connected to the SDI 2 output.
When you have finished using the device, disconnect the power supply from the wall outlet.

For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.

This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its currently valid version. Do not dispose of your old device with your normal household waste. Dispose of this product through an approved waste disposal firm or through your local waste facility. Comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility.