takustik BASS TRAPS
BASS TRAPSThese instructions are for the following products: CBT-37, CBT-37 Flock, CBT-37 Melamine, CBT-1, CBT-2, CBT-3, Melamine Cornertube, AC-37.
TOOLS
The following tools are needed for installation:
- Box Cutter
- Caulk Gun
- Pencil
- Level
- t.akustik glue
- Folding ruler or tape measure
We recommend using our t.akustik glue for installation.
UNBOXING
Open the package carefully! Inserting sharp objectsinto the package can damage the bass traps. Avoid using long, sharp tools for opening the package!
REMOVE PRODUCTS FROM PACKAGING
Carefully remove the products from the package. Bass traps come with two elements per package. Take care when separating the elements from each other, especially with melamine foam models.
DETERMINE THE POSITION
While determining the mounting positions, it helps to mark the walls and ceiling using a level and tape measure. The angle between the walls must be verified prior to installation.
PREPARE THE CAULK GUN
Carefully open the glue cartridge using a utility knife. Take care to point the knife away from your body. Thread the included nozzle onto the opening. Insert the cartridge into the caulk gun. For thicker lines of glue, you can use the knife to enlarge the opening of the nozzle.
APPLY THE GLUE
Apply the glue to the back of the bass trap in an even line along the outer edges. It also helps to apply some glue to the center of the bass trap in an X pattern, in order to hold the center firmly in place on both walls. Depending on the condition of the walls and corners, custom cuts may need to be made.
LET GLUE SET FOR 5 MINUTES
Before mounting the bass trap on the wall, let the glue set for 5 minutes on the element. This ensures that it can develop its full holding strength.
INSTALL THE BASS TRAP
Press the bass trap into the corner in the marked position and apply even pressure to the lines of glue for 2 minutes. Repeat the process for any additional elements and stack them on top of each other. That’s it!
TIP:Before mounting the bass trap on the wall, let the glue set for 5 minutes on the element. This ensures that it can develop its full holding strength. LET GLUE SET FOR 5 MINUTES Depending on the condition of the wall, it is recommended to apply a thicker line of glue by enlarging the nozzle of the cartridge using a utility knife.
This product is intended to be used to optimise the room acoustics. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use. Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard!
When opening the glue cartridge using a knife or a cutter, pay attention not to injure your fingers/hands. Risk of cutting! For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.Find more solutions for your room on our website: www.takustik.com
Share your installation with us on Instagram: www.takustik.com/instagram
Find more installation guides on YouTube: www.takustik.com/youtube
References
[xyz-ips snippet=”download-snippet”]