User manual for remotecontrolled outdoor outlet
facebook.com/telldus | |
@telldus |
Connect to a remote control*
* Remote Control only included in selected packages
Connect sensor to TellStick
Requires a TellStick and a Telldus Live account
Read this before installation
Remote-controlled outlets & remote control
- Remote control* has 3 channels and 1 group function.
- Each outlet has 5 memory settings.
- Blue LED indicates ON/OFF and programming status.
Installation
- Remove the plastic tab from the battery in the remote control*.
- Connect the outlet to mains power.
- Connect a lamp to the outlet. If there is a power switch on the connecting cable make sure it is switched on.
Unpair a single remote control* from an outlet:
- Keep the button on the outlet pressed for 7 seconds. The LED blinks slowly.
- Press the corresponding OFF button on the remote control* to remove the learned code (the learning mode is automatically disabled after 15 seconds if no button is pressed).
- The connected lamp blinks three times as confi rmation. Unpair all remote controls* from an outlet:
- Keep the button on the outlet pressed for 7 seconds. The LED blinks slowly.
- Within 7 seconds, press the button briefl y once more (the learning mode is automatically disabled after 15 seconds if no button is pressed).
- The connected lamp blinks three times as confirmation.
* Remote Control only included in selected packages
Specifications
Article number | 14732 |
Battery | 3V CR2032 |
Max resistive load | 3680 W |
Range | 0-30m |
Protection class | IP44 |
Protection class | I |
Frequency | 433.92 MHz |
Operating temperature | 0°C–35°C |
Power supply | 230 V~, 50 Hz |
Standby power/Standby | <1 W |
References
[xyz-ips snippet=”download-snippet”]