Trinity TR-4154D / Yamaha Raptor 700 Dual Full System Stage 5 Exhaust Installation Instructions

TR-4154D

(2015-2016) YAMAHA RAPTOR 700 DUAL FULL SYSTEM STAGE 5 EXHAUST

INSTALLATION INSTRUCTIONS

  1. REMOVE THE STOCK EXHAUST
  2. REMOVE BOTTOM SWING ARM PLASTIC AND GUARD.
  3. UNBOLT AND REMOVE THE REAR SHOCK ASSEMBLY
  4. BOLT ON THE TRINITY HEAD PIPE, BUT LEAVE SLIGHTLY LOOSE
  5. INSTALL THE 6MM BOLT, SPACWER AND TRANSFER THE HEAT SHIELD.
  6. TUCK ALL THE WIRES AS CLOSE TO THE ENGINE CASE AS POSSIBLE
  7. SLID THE “Y” COLLECTOR OVER THE NEW HEAD PIPE AND ATTACH THE SPRINGS
  8. RE-INSTALL THE REAR SHOCK ASSEMBLY AND BOLT THE SWING ARM GUARD BACK IN PLACE
  9. INSTALL BOTH THE TAIL PIPES AND ATTACH THE SPRINGS
  10. REMOVE EACH FRONT BOLT FROM THE GRAB BAR
  11. SLIDE THE BILLET SILENCER MOUNTING CLAMPS OVER THE SILENCERS AND SLIDE THE SILENCERS OVER THE MID PIPES.
  12. SLIDE THE BILLET SILENCER MOUNTING CLAMPS INTO POSITION TO BOLT TO THE MOUNTING LOCATIONS FOR THE GRAB BAR.
  13. BOLT SILENCERS TO MOUNTING BAR LOCATION WITH SUPPLIED 8MM X 55MM BOLTS
  14. TIGHTEN ALL HARDWARE MAKING SURE TO ALIGN THE EXHAUST SYSTEM AS YOU GO.
  15. ATTACH ALL SPRINGS
  16. ENSURE THAT NO WIRES ARE COMING IN CONTACT WITH THE EXHAUST. ZIP-TIE WIRES IF NECESSARY.

Trinity TR-4154D / Yamaha Raptor 700 Dual Full System Stage 5 Exhaust Installation Instructions – Trinity TR-4154D / Yamaha Raptor 700 Dual Full System Stage 5 Exhaust Installation Instructions –

[xyz-ips snippet=”download-snippet”]

Posted

in

by

admin

Tags:

, , , ,