TRIPP-LITE Dual Flat-Screen Flex-Arm Desk Clamp DDR1327SDFC-1 Owner’s Manual

Owner’s Manual

Dual Flat-Screen Flex-Arm Desk ClampModel: DDR1327SDFC-1

CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!WARRANTY REGISTRATIONRegister your product today and be automatically entered to win an ISOBAR® surge protector in our monthly drawing! tripplite.com/warranty

http://www.tripplite.com/warranty

Safety Instructions

Note: Read the entire instruction manual before you start assembly and installation.

WARNING

  • Do not begin the installation until you have read and understood the instructions and warnings contained in this manual. If you have any questions regarding any of the instructions or warnings, please visit tripplite.com/support.
  • This mounting bracket was designed to be installed and used ONLY as specified in this manual. Improper installation of this product may cause damage or serious injury.
  • This product should only be installed by someone of good mechanical ability, with basic building experience and a full understanding of this instruction manual.
  • Make sure the mounting surface can safely support the combined load of the equipment and all attached hardware and components.
  • If mounting to wood wall studs, make sure mounting screws are anchored into the center of the studs. The use of a stud finder is highly recommended.
  • Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
  • Tighten screws firmly, but do not overtighten. Overtightening screws can damage the items, greatly reducing their holding power.
  • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

Warranty and Product Registration

5-Year Limited WarrantySeller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanship for a period of 5 years from the date of initial purchase. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, at its sole discretion.THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction.)

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application.

PRODUCT REGISTRATIONVisit tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!** No purchase necessary. Void where prohibited. Some restrictions apply. See website for details. Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice. Photos and illustrations may differ slightly from actual products.

Component Checklist

report this ad

IMPORTANT: Ensure you have received all parts according to the component checklist prior to installing. If any parts are missing or faulty, visit tripplite.com/support for service.Package MPackage P

Assembly

  1. Install the Pole and Desk Clamp Assembly
  2. Install Adapter Bracket Assembly
  3. Desk InstallationNote:min. desktop thickness=10 mm (.4″)max. desktop thickness=90 mm (3.5″)• Determine approximate location for mount, keeping in mind display size, height adjustment and pitch/roll requirements.• Slip the desk mount assembly over the edge of desk so that clamp fully contacts desk edge.• Turn the knob to adjust the clamp to edge of desk and secure it tightly.
  4. Install Top VESA Plate Screws
  5. Install VESA Plates
  6. Adjust VESA Plates
  7. AdjustmentMaintenance• Check that the bracket is secure and safe to use at regular intervals (at least every three months).• Please visit tripplite.com/support if you have any questions.

1111 W. 35th Street, Chicago, IL 60609 USA · tripplite.com/support 21-05-214 · 93-3E6D_RevA

References

[xyz-ips snippet=”download-snippet”]


Posted

in

by