AF-5G23-S45 Quick Start Guide
Package Contents
Installation Requirements
- 5 GHz airFiber radio (sold separately)
- 13 mm wrench
Other Requirements
- Clear line of sight between airFiber radios
- Clear view of the sky for proper GPS operation
- Vertical mounting orientation
For tower installations, at least 3 m below the top of the tower
- Ground wires – min. 10 AWG (5 mm ) and max. length: 1 m. As a safety precaution ground the airFiber radio to grounded masts, poles, towers, or grounding bars.
WARNING: Failure to properly ground your airFiber radio will void your warranty. - (Recommended) 2 Outdoor Gigabit PoE surge protectorsNote: For guidelines about grounding and lightning protection, follow your local electrical regulatory codes.
- Outdoor, shielded Category 6 (or above) cabling and shielded RJ-45 connectors are required for all wired Ethernet connections.
Hardware Installation
IMPORTANT: Handle the antenna with care. Deformations in its reflector may reduce the antenna’s effectiveness.
1
2
3
Note: The GPS antenna is included with the airFiber radio.4
5
6
7
8
Aligning the Antenna
Optimize the airFiber link by adjusting one end of the link at a time. Refer to the airFiber X radio Quick Start Guide for additional details.Note: Repeat steps 1 and 2 as needed to optimize the link.
1
2
3
4
5
6
Specifications
|
AF-5G23-S45 |
|
| Dimensions | 378 x 378 x 290 mm (14.88 x 14.88 x 11.42″) |
| Weight | 3.4 kg (7.5 lb)(Mount Included) |
| Frequency | 5.1 – 5.9 GHz |
| Gain | 23 dBi |
| Max. VSWR | 1.5:1 |
| Wind Survivability | 200 km/h (125 mph) |
| Wind Loading | 190 N @ 200 km/h (43 lbs @ 125 mph) |
| Polarization | Dual Linear |
| F/B Ratio | 33 dB |
| ETSI Specification | EN 302 326 DN2 |
| Mounting | Universal Pole Mount forØ 38 – 64 mm (Ø 1.5 – 2.5″) Poles |
Safety Notices
- Read, follow, and keep these instructions.
- Heed all warnings.
- Only use attachments/accessories specified by the manufacturer.
WARNING: Do not use this product in a location that can be submerged in water.WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Electrical Safety Information
- Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified may result in improper operation, damage to the equipment, or pose a fire hazard if the limitations are not followed.
- There are no operator serviceable parts inside this equipment. Service should be provided only by a qualified service technician.
Limited Warranty
ui.com/support/warrantyThe limited warranty requires the use of arbitration to resolve disputes on an individual basis, and, where applicable, specify arbitration instead of jury trials or class actions.
Compliance
RF Exposure Warning
transmitter. For the specific separation distance, refer to the Quick Start Guide for your Rocket device (transmitter).WEEE Compliance StatementDeclaration of ConformityOnline Resources
© 2021 Ubiquiti Inc. All rights reserved.https://dl.ubnt.com/qsg/AF-5G23-S45/AF-5G23-S45_EN.html
References
[xyz-ips snippet=”download-snippet”]