ULINE Deluxe Pusher Tensioner Instructions

ULINE Deluxe Pusher Tensioner

GENERAL SAFETY

IMPORTANT: Read all operating instructions.

STRAP BREAKAGE HAZARDPlace the strap correctly around a properly positioned load. Improper strapping or unstable or shifted loads may result in a sudden loss of strap tension during tensioning, causing you to lose your balance and fall. Use edge protectors if the load corners are sharp.

Position yourself to one side of the strap and keep all bystanders away. Do not position yourself in line with the strap during tensioning and sealing. Severe personal injury from flying strap or tool can result.

REFERENCE

OPERATION

1. Thread the strap through the seal and  around the bundle. Thread the strap through the seal again. Bend the lower strap sharply to hook the lower lip of the seal, then pull the slack out of the strap.
2. Squeeze the handles together to lift the feed-wheel. Insert the strap into the breaker nose slot and push the tool up against the seal. (See Figure 2)
3. Stand to one side of the strap line. Tension the strap by raising and lowering the tension handle. (See Figure 3)
4. When desired tension is reached, push the drive pawl forward and lower the tension handle until it contacts the lift arm. (See Figure 4)
5. Use a single notch sealer to seal the joint. (See Figure 5)
6. Break off excess strap at the seal. Raise the tool perpendicular to the seal, then lower it. (See Figure 6)

WARNING! Inspect the tool daily and replace worn or broken parts. Tool operation can be affected and result in serious personal injury.