ULINE H-7053 Convergence Mesh Task Chair Installation Guide

Table of Contents

Back Support x 1

Seat Cushion x 1

Armrest x 2

5- star Base x 1

Screw x 3

Caster x 5

Washer x 3

Gas Lift x 1

Insert casters into legs of five-star base. Turn base right side up. Insert gas lift into center of base. (See Figure 1)
Slide armrest into bracket on bottom of seat cushion until it clicks. Push in lever toward armrest to lock. Repeat on opposite (See Figure 2)
Position back support in slot between bottom of seat cushion and mechanism. Align holes and use three screws with washers to attach back support to (See Figures 3a – 3b)NOTE: Use Allen wrench to tighten all screws.
Slowly lower assembled chair and insert center of mechanism into gas Press down on seat to secure in place. (See Figure 4)

Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the To lower seat height, lift lever up while sitting.
Upright Tilt Lock – To lock chair in an upright position, push the lever in toward the center of the seat. To restore tilt, pull lever out. Chair has standard tilt; the seat and back tilt simultaneously at the same
Tilt Tension – To increase tilt tension, turn knob To decrease tilt tension, turn knob counterclockwise.
Lumbar Support – To position higher or lower on the back, slide the lumbar support up or
Armrest Adjustment(A) Height – To adjust arm height, press the button under armrest pad and move the armrest up or(B) Width – To adjust arm width, pull lever under seat away from armrest and move the armrest in or Push lever in toward armrest to lock.