ULINE H-8669 Stainless Steel IBC Instructions
CLOSURE INSTRUCTIONS
Pursuant to the requirements of the Department of Transportation in CFR 49 Part 178.2(c)(1), this method of closure should be used to ensure that containers have been closed in the same manner as when they were initially tested.
RING CLOSURE INSTRUCTIONS
- Each IBC is equipped with an emergency vent in the container lid which fits on the top opening. This vent must be inspected before each shipment, and must be replaced if faulty.
- Inspect container lid and gaskets for damage, and replace if necessary. The container lid is installed on the top opening with a clamp ring.NOTE: Use a non-sparking mallet to ensure the clamp ring is fully secured on the gasket and lid. The mallet should be used to strike in a horizontal position (towards the side of the clamp ring) first starting at the twelve o’clock position, then three, nine, five and ending at seven.
- After tightening bolt to a torque of 30 foot pounds, the lock nut must be firmly tightened into place.
PLUG AND VENT
- The 2″ bung plug, and the 3″ fill cap, both require a gasket to seal and be tightened to a torque of 30 foot pounds for proper sealing.
TORQUE SPECIFICATIONS
FITTING | TORQUE |
Container Lid | 30 Ft. Lbs. |
3″ Fill Cap | 30 Ft. Lbs. |
2″ Bung | 30 Ft. Lbs. |
Read More About This Manual & Download PDF:
[xyz-ips snippet=”download-snippet”]