ULINE Horizontal Paper Cutter With Straight Edge Installation Guide

HORIZONTAL PAPER CUTTER WITH STRAIGHT EDGE1-800-295-55100521 IH-192uline.com

ASSEMBLY

TO ASSEMBLE FOR COUNTERTOP USE

1. Remove the paper cutter from the box and grasp the bottom crossbars. Pull these crossbars apart until they lock in the open position. (See Figure 1)
2.  Insert the included rubber feet into the holes on the bottom crossbars. (See Figure 2)
3. Set the cutter upright (rubber feet down) on the workstation. With one hand on the dowel, pull the blade towards the workstation top until the straight edge blade locks into the open position. (See Figure 3)
4.  Remove the dowel and slide it through the core of the material intended for use on the cutter. Core plugs with 1″ openings are included and are recommended for use with this product.
5.  Place the exposed ends of the dowel into the dowel sockets, one on either side of the cutter. Then, carefully push the blade toward the material until the straight edge blade rests securely against the roll.
6. Feed material through the underside of the straight edge blade to dispense and tear.

WALL MOUNTING INSTRUCTIONS

1.  Follow step 1 of the countertop instructions.
2. With appropriate hardware (not included), mount the cutter to the desired surface through the holes in the bottom crossbars. Mount with straight edge blade facing the ceiling.
3.  Follow steps 3-5 of the countertop instructions to load the cutter.
4.  Feed the material away from the wall to dispense and tear.